Search results

  1. alldodge

    Trim gauge creeping higher

    Yes, to both questions Depends on which control is on the boat as to where the trailer up is.
  2. alldodge

    5.7gi reman shutting off on test stand

    Assuming your using the injectors from the 5.0, which Gi was it? Do you know which fuel tables where used for the remaping of the fuel tables? Reason for asking, is the tables are different depending on which injectors and the pressures are used. The 5.0 Gi can be from 30 to 60 psi, and the...
  3. alldodge

    Digital Throttle/Shift (DTS) Shift Adjustment ???

    Agree, if you go to Mercury site, it shows the same pic. Can also find the Axis components
  4. alldodge

    Trim gauge creeping higher

    The down function should stop when you release the switch. It will run as long as the switch is held in the down position. The up limit is adjusted by the trim limit on the starboard side of the drive. The limit cuts the drive from coming up any further. There should be another button for...
  5. alldodge

    7.4 mpi mericruiser cranks over but wont start.

    Which 7.4 MPI, have a serial number? Assuming this is the same motor that was overheating after ingesting sand?
  6. alldodge

    Digital Throttle/Shift (DTS) Shift Adjustment ???

    Don't know of one later then 28. Might be a later install manual or separate Digital manual, don't know Looking at Mercury parts (only place to see your motors) it shows the shift bracket better and there is not any tool that could be used so far as I can see other then with mechanical shift
  7. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    Talk is cheap, and he to may have been told it was the same. It looks good enough, you would get more as the rpms increase
  8. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    I would bet a different ratio
  9. alldodge

    Engine no power under load

    What ever helps you get through the night
  10. alldodge

    Dean's List gets another motor

    That's my shop :rolleyes: I think after 6 years I'm also going to get the little boat put back together also. Sure hope so
  11. alldodge

    vapor separator tank removal and upgrade

    The pic was just for reference and is not like yours. Yours is below, just note all excess fuel not used must go somewhere. The VST returns to VST tank, the cool fuel returns to filter
  12. alldodge

    Digital Throttle/Shift (DTS) Shift Adjustment ???

    Ted, looking at parts break down the DTS doesn't use the same shift plate. What does your manual show for setting? https://www.mercruiserparts.com/bam/subassembly/31758/15323/370
  13. alldodge

    Dean's List gets another motor

    Heads went to the shop and found some bent valves. The guides were all drilled out and bronze bushings were pressed in, cheap fix. So we have a Merc Reman that had several problems. So much for Merc quality Heads should be back next week and can start putting it back together.
  14. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    Doesn't state in manual, but I would guess it should be same as all SBC and 24* from base timing.
  15. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    You have the flat top cap. There is no adjusting timing with a timing light, computer does it all
  16. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    If your getting full advance, no If your not getting full advance, yes You have tested for this prior and said you were getting advance
  17. alldodge

    Volvo Penta 4.3GL-D Tapping Noise Videos attached

    Collapsing lifter. Take a long screw driver and with valve covers off, place the driver on each rocker stud and hold the handle end against your ear. Find out where the sound is most pronounced
  18. alldodge

    Digital Throttle/Shift (DTS) Shift Adjustment ???

    Agree not much out there, but very few parts also that does the shifting. I might try swapping the shift actuators to see if it goes with it. If no change, then it's the lower cable or the drive
  19. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    And more fuel doesn't necessarily mean more power
  20. alldodge

    Mercrusier 350 MAG MPI - RPM issue under a load

    Unless you "really" know what your seeing and the test methods, you do not know what your seeing Have a look at this thread and see if you can tell what Smitty is trying to convey https://www.offshoreonly.com/forums/general-q/376681-recent-500-efi-injector-test-vs-another-claimed-replacement.html
Top