Search results

  1. Scott Danforth

    LS Swap...?

    That's funny as I built a pair of 1940's one with a big block
  2. Scott Danforth

    1981 Custom Craft 16ft deck restoration

    Your transom and stringer rotted before the floor To do it with plywood and fiberglass yourself will be about $1500-2000 $200 in wood $200 in PPE $100 in cloth $300-500 in resin $400 in foam $300 in misc fiberglass supplies $200 in sanding discs blades, etc
  3. Scott Danforth

    Short or long water pump?

    While the Volvo engine uses GM pulleys. You won't find them in an automotive equivalent Either visit your GM industrial dealer or order thru Volvo Me personally, would soak the pullies in oxalic acid for a week (to remove all the rust). Wire brush them and paint them. Your out maybe $20
  4. Scott Danforth

    Just thought I'd share a nice photo.

    Though it was : "Nearly Winter" "Winter" "Still Winter" "Bad Sledding"
  5. Scott Danforth

    Battery sparking

    your battery lugs were not cleaned with 150 grit sand paper your battery clamps are wrong for a marine application as stated above, incorrect or dirty connections will spark.
  6. Scott Danforth

    First time winterizing 4.3 mercruiser, alpha one.

    did you drain the block and manifolds first?
  7. Scott Danforth

    Hardtop repair

    repairing the cracks is just like repairing anything fiberglass. agreed, it looks like the core material is damaged. proper repair would be to remove the top, cut it apart, replace the core, reglass the top, re-gel or paint and then reinstall.
  8. Scott Danforth

    1972 Grew SS245

    To each their own. A 52 year old marine motor would have lots of rust in the passages Nothing special about the marine heads. They are just truck parts
  9. Scott Danforth

    Who works on OMC 800 series outdrives-Sacramento area?

    welcome aboard. you will be hard pressed to find anyone that works on these anymore
  10. Scott Danforth

    Question on bimini top location

    FWIW, you could simply buy a patio umbrella and clamp it to the forward seat. thats all that Dad had in his boat for decades. the cheap $15 patio umbrella with a bit of rope on the second one. yes, the first one went sailing in a wind gust
  11. Scott Danforth

    Winter Prep for So Cal

    you need to do your annual PM's run the fuel tank down oil change and filter fuel filter gear oil change pull the drive to inspect alignment, gimbal bearing, bellows pull the raw water impeller for winter however not sure why you wouldnt just run it year round.
  12. Scott Danforth

    165 MERCRUISER

    look it up yourself https://www.greatlakesskipper.com/mercury-classic-boat-gauge-set-silver-black-5-pc-set
  13. Scott Danforth

    Paint question for aluminum hull boats

    whats there to explain. unless you have a baked on paint from the factory, you need primer
  14. Scott Danforth

    Winter Storage

    make sure you look at what is needed for both outboards. being low output. wallyworld gear lube would be fine OMC spec'd their premium SAE 90 hypoid gear oil and that would be fine in the Mac
  15. Scott Danforth

    Mercruiser 3.0 to Mercruiser 4.3 swap

    thought you were swapping in the whole long-tail I would try to keep the drive whole vs splitting if you have access to the whole drive from behind the 4.3
  16. Scott Danforth

    Power connectors.....?

    stating SAE in the name doesnt mean they meet any SAE requirement. you want a marine rated power outlet on a boat and most of the amazon chineseum products are simply plated tin your GPS, depth finder both have power cables that are water proof. install them and simply use the covers provided...
  17. Scott Danforth

    1972 Grew SS245

    I would part out in a heartbeat
Top