Search results

  1. Scott Danforth

    My office earlier this week

    TACO Seating
  2. Scott Danforth

    Is it feasible to straighten a prop shaft?

    With a dial indicator and shop full of tools and years experience, you probably can get it straight.
  3. Scott Danforth

    Rotten Boat Factory

    Definition of design life.....
  4. Scott Danforth

    MerCruiser 5.7/350 MIE flywheel.

    The inboard flywheels are different than the I/O. However plenty out there new and used...
  5. Scott Danforth

    Rotten Boat Factory

    They will probably be on iboats as projects long after they rot
  6. Scott Danforth

    My office earlier this week

    Just a view from the mobile office Tuesday
  7. Scott Danforth

    1990 Bayliner Capri 2050 5.0 V8 200hp

    for a prop on that boat, start with the prop that is on the boat. from there, you need to determine if you stay with what is there gets the engine to WOT, or you need to go up/down in pitch. if you can swing a 15" prop, I would go that route. you may need to change the anode to do so your...
  8. Scott Danforth

    New (old) hard top pontoon owner

    BTW, the chinesum knockoffs on amazon are copies of the old Duff Norton LM series Look for IP 65 rating (rain proof)
  9. Scott Danforth

    Steering not working. HELP!

    I really wish you would have came here before you bought a boat with an obsolete drive The stringer 400 was only behind the 2.5 liter and 3.0 liter 4 cylinders The 5.0 would have a stringer 800. Most likely your true-course steeting is jacked up. It may be something simple, or it may cost...
  10. Scott Danforth

    Issue with Electronics resetting when starting boat

    start by cleaning the batter, cable, block connections. you have a bad connection somewhere
  11. Scott Danforth

    New (old) hard top pontoon owner

    start with two bits of information total travel between up and down. this will be actuator stroke total weight of hard top. you will need this to determine actuator force.
  12. Scott Danforth

    2006 Volvo 5.7 osi-d crank no start

    adjustable valve train. therefore 3/4 to 1 turn past zero lash (no vertical movement)
  13. Scott Danforth

    WHAT DID I JUST BUY?

    hope the transom and stringers are not rotted
  14. Scott Danforth

    New (old) hard top pontoon owner

    if you have to move it up and down often. just add 4 electric actuators
  15. Scott Danforth

    1969 mercury 110 9.8 go fuel pump .

    mercury used variations of the same pump for as many years as johnnyrude used their version. they both bought them from Walbro and other sources back then
  16. Scott Danforth

    How to get boat launched daily when Travel Trailer camping?

    drive to camp site. Check in disconnect trailer and level it inflate boat pick up boat and turn sideways on truck bed. and strap to bed. its only #150. can do it by yourself, or if you have someone with you. drive down road with boat strapped sideways. get to water, toss it in and strap on...
  17. Scott Danforth

    Finding a short

    is there any wire anywhere screwed to the hull? did someone try to use the hull as a ground? did you use treated lumber on the trailer or in the boat?
  18. Scott Danforth

    WHAT DID I JUST BUY?

    used ones are $600 to $1000, chinesium knock-offs are $600-$700
  19. Scott Danforth

    Long cranking and turnover to start after warm. Questions about vapor lock and leaky Injectors

    are you saying the motor spins for 5-7 before she fires, or the engine turns over really really slow for 5-7 seconds before it speeds up enough to fire?
Top