Search results

  1. R

    Mercruiser 140 1976 Down trim limit.

    Hi, That explains a lot. So is there nothing of protection if you press too long? That could so easily have been included with the trim limit switch, too bad they didn't.
  2. R

    Mercruiser 140 1976 Down trim limit.

    Hello people, Would love your help with adjusting my power trim limit. I have a boat with a pre alpha Mercruiser 140 sterndrive and then alpha one trim cylinder. Now I am in the process of adjusting it but I am unsure what distance to use for this. In the book for a pre alpha they indicate...
  3. R

    gimbal bearing alignment

    My full project post
  4. R

    Browning monte carlo 17ft Full Restore

    I wanted to share with you my latest project. I myself am a graduated for yacht and interior construction. About two years ago in the corona period I was able to take over a boat for free. Knowing that it needed mega work but I went into the plan with good intentions. I had 0 knowledge of...
  5. R

    gimbal bearing alignment

    Soon i will make my mega post about my project. Here a little sneakpeak
  6. R

    gimbal bearing alignment

    So what do you guys advise me to do now. I ordered a new bearing so I think I'll just try that one on and see if that goes better. Also, while I'm at it, replace the rubber ring behind it as well or is that not necessary?
  7. R

    gimbal bearing alignment

  8. R

    gimbal bearing alignment

    So I've been working on a restoration on a classic 17ft Browning monte carlo for months. So now I have arrived at replacing all the bellows and gaskets. When removing my sterndrive from the gimbal housing, my bearing stuck to the shaft. I found this strange as you see people everywhere using a...
View older results
Top