Search results

  1. C

    Flush kit install

    Looking for direction on installing a fresh water flush kit on a 2007, 24ft Rinker, deep V with a Mercruiser 350 Mag MPI. There's a larger red hose , maybe 1 1/4 inch ID, that runs along the lower starboard side of the engine. I'm guessing that it runs from the transom to the water pump? Is...
  2. C

    Yamaha 80hp, 4 stroke runs rough

    Here's the history. recently bought this pontoon with a 2001 80hp, 4 stroke Yamaha. Knew it had an issue when I bought it. Previous owner brought it to a local marina and they said it needed the carbs rebuilt. After sitting at the marina for weeks without getting worked on, the owner went and...
  3. C

    running rough

    Just purchased a pontoon boat with a 2001 80hp Yamaha 4 stroke. Motor looks very clean. Knew it had a problem when purchasing. Previous owner said boat was running fine for months then problem occurred where it wouldn't get over about 1200 rpms. They changed the fuel filter and fuel lines...
  4. C

    Only runs when cranking

    Have a Mercruiser 4.3 ltr, 1995. Recently purchased, clean boat. Carbureted, electronic ignition. Had it on the lake and was running great. Trailered it home during a severe rainstorm and got lots of rain and moisture in the engine compartment. Went to the launch a few days later and it'll...
  5. C

    65hp evinrude no power

    I have a 1973, 65hp Evinrude that I need help with. The motor overheated to the point that it stalled. Since then I have changed the impeller, head and head gasket, exhaust manifold and gaskets, plugs and all 3 coils. I had it on the water today for the 1st time since overheating and it had...
View older results
Top