Search results

  1. M

    1996 ev 25 hp 2 stroke not peeing

    This kit seemed especially cheap. The housing was 3d printed. Anyway I ordered an oem kit and will inspect the upper copper tube grommet when I am in there. Was run on muffs as I have done with countless other motors without issue
  2. M

    1996 ev 25 hp 2 stroke not peeing

    Picked up a nice motor 1996 evinrude short shaft model number e25teeda. I noticed it didn't pee right away. Wouldn't see a stream until 20 seconds or so after starting. I've run a bunch of these and always had them pee right away. I dropped the lower unit down and inspected the pump. The...
  3. M

    Evinrude 25 hp lower unit front stud

    The bolt turned into a stud worked great thanks guys. Much appreciated
  4. M

    Evinrude 25 hp lower unit front stud

    Genius. Thank you
  5. M

    Evinrude 25 hp lower unit front stud

    Stud as discontinued.Be great if Anyone knows what size I need and where it's available
  6. M

    Evinrude 25 hp lower unit front stud

    1993 ev 25. Fought that god forsaken front stud but finally got the unit removed. I must have stripped the threads on the stud. The nut won't tighten. Anyone ever successfully removed that stud? Any other options for me here? Thanks
  7. M

    Recommendation for gps display

    I have a 19 ft wellcraft center console. I boat on the nj coast can someone recommend what electronic i need that can trace my route and also show where it's safe to navigate. I feel like I'm just winging it at times and it's very unsettling. I don't feel like the channels are well marked and...
  8. M

    Yamaha 4 hp 2 stroke nightmare

    1990 4 hp. By the outside appearance it looks great but the telltale water coming out was too hot to touch. New impeller. Same deal. Decided to check the thermostat and look at all this corrosion! Pulled the head cover and was packed with salt. No water getting in to this area. Compression 150...
  9. M

    Hub weight rating

    Not sure. The seal went bad looks like some grit might have gotten in there. I made it back home 400 miles and no grease coming out of the seal on the tractor supply hub. Thanks for the help guys.
  10. M

    Hub weight rating

    Ok thanks. I'll upgrade the seal once I'm back home.
  11. M

    Hub weight rating

    Had a bearing go bad on my loadrite single axle roller boat trailer. I got a whole pre assembled hub at tractor supply but want to make sure the weight rating is OK. Box with the tractor supply hub says 1,750 lb capacity and the label on the trailer is attached below. Advertisement for my...
  12. M

    Tire grew in size?

    I am on vacation. Must have had a few too many when I began the post . Lol thanks
  13. M

    Tire grew in size?

    Yes please
  14. M

    Tire grew in size?

    I think you are right lol. Can I delete this post to end the bleeding ?
  15. M

    Tire grew in size?

    Sorry. The picture shows the affected tire next to my spare tire. Both load star but different models. Both trailer tires with st 215/75/14 size on sidewall. The non affected tire is installed on the other side of the trailer and is the same make and model as the affected tire. The affected...
  16. M

    Tire grew in size?

    Sorry they are different models. When I compared the fat tire to the exact model and make on the other side of the trailer there is the same difference as when comparing to my different model spare tire from the photo.
  17. M

    Tire grew in size?

    When compared to exact brand and size is where they are different
  18. M

    Tire grew in size?

    St 215/75/13 tire on my boat trailer has developed a problem. The one tire on the left has expanded about 1 1/2 inches compared to the other side(same brand and model tires with manufacturer date within a few weeks of each other (2019). Tires have about 2,500 miles on them. Anyone seen this...
  19. M

    Kill switch tether yamaha 4 hp 2 stroke

    Bought a 1990 yamaha 4 hp 2 stroke. It has a red stop button. I want to put a newer style stop button with lanyard and clip in the event of man overboard it'll stop the motor. Anyone do this before?
  20. M

    Short vhf antenna

    Perfect thank you
Top