Search results

  1. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    could it be 3 prong oil pressure switch not working or break in wiring, if electric fuel pump gets initial charge from starter ,then swicthes to 3 prong would charge from fuel pump still be present at the fuel pump posts
  2. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    thanx , i tried to dribble fuel ,but no success, i do want to check the metering rods , i multimetered the carter electric fuel pump and have question ,should the multimeter go up to 10.925 volts when starting, ,then go to 0.00 when motor starts ,or should it hold at 10.925 while motor is...
  3. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    disconnected tach ,still no luck,could a bad thermostat cause a bogg to die? went and unhooked thermostat housing to exhaust hose ,at exhaust ,stuck hose in a bucket started motor til it died as usual,water flowed out ,but what was strainge isafter motor shut off the hose sucked all the...
  4. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    question how much fuel should a edelbrock 1409 marine carb have in its fuel bowls after motor dies, i get three wot strokes and its empty,could be my electric fuel pump is shutting off ,have fuel pressure test , also i noticed my tach is fine till it starts to bog and then it pins ,and then goes...
  5. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    i took out the 7th plug and cranked motor for maybe 5 seconds ,no water coming out ,repeated plug 8 and no water coming out ,as for recheck fuel filters, spin on, and any inline or on carb filters. ,i tried my boat gas tank thru seperator,then tried kicker gas tank,portable, no luck,also took...
  6. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    also get a sound never noticed before ,when engine shuts down ,i hear girgling for stb side exhaust hose from thermostat housing never noticed that sound before
  7. newtoboat101

    5.7 vortec motor starts ,then bogs and dies

    1996 5.7 vortec ,alpha 1 gen 1 with edelbrock 4 barrel, delco distributor,,carter electric fuel pump with orca cooling half system ,motor starts fine, revs fine ,but seconds later when water comes out of exhaust ,motor changes boggs for a while 5-20 seconds then dies ,starts right back up ...
  8. newtoboat101

    Trim pump wiring acting opposite

    thank you Chris1956 ,i have to call sei and see what they say, totally blowing my mind , so you said turned upside down at anytime ,could delivery have caused this ?
  9. newtoboat101

    Trim pump wiring acting opposite

    so, would that be at anytime thru logistics ,sure the delivery service may have turned upside down nothing on box says keep upright or this side up ,if that was the case can it be corrected?
  10. newtoboat101

    Trim pump wiring acting opposite

    ok the trim limit works but opposite ,so i use green wire to raise outdrive maybe half way up ,then try trailer switch nothing,then use blue wire to lower outdrive a little til i hit my limit then switch to trailer wire and outdrive continues to lower ,so why is everything backwards?
  11. newtoboat101

    Trim pump wiring acting opposite

    still baffled about why its opposite ,switched wires going to trim limit dial ,,but still the same blue and 4th wire outdrive goes down ,green goes up ,now this pump is brand new almost a plug and play ,could my wires be wrong from factory (SEI),How to find out if wiring on pump is correct
  12. newtoboat101

    Trim pump wiring acting opposite

    yes ,your correct trailer button thank you
  13. newtoboat101

    Trim pump wiring acting opposite

    what does 4th wire do,i can see where it connects
  14. newtoboat101

    Trim pump wiring acting opposite

    i will check that ,little in depth i took an old plug end that goes to 3 switch cut wires and put plug in pump with spliced wires i tapped blue with red ( red is positive) the drive goes down ,when i tap red and green together drive goes up ,so i think this why my 3 switch only raises outdrive...
  15. newtoboat101

    Trim pump wiring acting opposite

    Hello. Added new trim tilt pump and new cylinders and was adding a 3 button switch which I was not been able to get it to work properly so I went back to my old wiring and toggle switch. . so I was multi metering and alligator clip check and for some reason the blue wire brings my outdrive all...
  16. newtoboat101

    ALPHA 1 GEN 1 TRIM CYLINDER (NEW)WILL NOT GO ALL THE WAY DOWN

    bought both pump and trim cylinders from SEI ,don't see any trim limit spacer ,in description
  17. newtoboat101

    ALPHA 1 GEN 1 TRIM CYLINDER (NEW)WILL NOT GO ALL THE WAY DOWN

    Yes old ones went down further than these ,they did not bottom out ,but the angle of my outdrive was more down ,now it looks to be ,with new pistons sitting at the out trim max. the cylinder retract to 21 1/4 inches center to center nut to nut
  18. newtoboat101

    ALPHA 1 GEN 1 TRIM CYLINDER (NEW)WILL NOT GO ALL THE WAY DOWN

    thanx for down line confirmation ,when operating properly they do not go all the way in ,but mine are coming up even short of that by 2 to 3 inches
  19. newtoboat101

    ALPHA 1 GEN 1 TRIM CYLINDER (NEW)WILL NOT GO ALL THE WAY DOWN

    alpha 1 gen 1 ,bought and installed new trim pump complete, trim cylinders, and new lines, but now my trim cylinders will not go all the way down , tank is full ,goes up and down fine ,just won't go all the way down ,about 2 or 3 inches short any help greatly appreciated ,and which line on...
  20. newtoboat101

    trim sender (starboard) wires

    thank you very much ALLDODGE
Top