Search results

  1. Scott Danforth

    Only goes 20 MPH

    Did you check the burned up rubber bits in the exhaust? Flappers? Exhaust hoses?
  2. Scott Danforth

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    Ted, you are an IT professional..... Imagine the same car owned by a non-IT person
  3. Scott Danforth

    Prop Question

    What RPM are you able to get the motor up to at WOT
  4. Scott Danforth

    Flex Seal on a Leaky Aluminum Boat?

    Flex seal is basically roofing tar It is not UV stable, and it cracks and fails
  5. Scott Danforth

    Dean's List gets another motor

    Sounds about right
  6. Scott Danforth

    5.0 OSi-JF overheating at speed

    My guess the hose connection at the drive. Crawl under the boat with the drives up and look up
  7. Scott Danforth

    Dean's List gets another motor

    Tipping a beer for you
  8. Scott Danforth

    1987 Bayliner Capri 1950 OMC Cobra bowrider starter bolt broke off.

    Hydrolock will break bolts
  9. Scott Danforth

    Can’t get on plane

    https://www.3m.com/3M/en_US/p/d/b40070719/ https://www.wd40.com
  10. Scott Danforth

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    With a diesel swap, 6-speed, atlas II transfer case?
  11. Scott Danforth

    Can’t get on plane

    there are a few tricks to get the gaskets off and prevent them from sticking in the future.
  12. Scott Danforth

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    Stealth conversions sold everything you needed. the website is https://jagsthatrun.com/. I still buy VSS parts,etc from them. I have their swap manual for swapping TPI engines and LT1 engines in jags, Mercedes, etc. putting ford Mustang (fox body) 5.0/5-speeds into volvos was so easy, half...
  13. Scott Danforth

    Lower Unit Gear Oil Running Temp ?

    Just replace the seals and use a good marine gear oil. you are overthinking it. gear oil temp will only be 1 or 2 degrees above the water temp while operating, and will be water temp when stationary. so if the water isnt frozen, the water in your leaking gearcase isnt frozen. a temp sender...
  14. Scott Danforth

    Can’t get on plane

    here is the link to Mikes if your google fu isnt strong. https://www.carburetor-parts.com/
  15. Scott Danforth

    Trailer needs new axle. Need ideas.

    measure your axle stub. length, diameters, etc. Be accurate. as in use a dial caliper then talk to your local trailer shop.
  16. Scott Danforth

    New here looking for advice..

    build quality on the boat only mattered back in 1978 when the boat was new. everything else after that comes down to car, condition, maintenance, condition, condition , condition, condition the issue with all vintage fiberglass boats is as some point, you will be doing fiberglass repair...
  17. Scott Danforth

    Y- Pipe Question

    the idle relief ports are needed to reduce the back pressure enough so the boat continues to run at idle.
  18. Scott Danforth

    . . . and I Thought Hi-tech Boat Engines Were Bad . . .

    Ted, if needed you could always strip out the 160# of electronics and wiring, do a stand-alone engine ECM
  19. Scott Danforth

    Can’t get on plane

    Stop firing a parts cannon at your boat. Start diagnosing what the problem may be The mechanic probably doesn't want to work on the Rochester carb because unless he is 55 years old or older, probably has never seen one. The last ones came in boats back in 1989 and in cars/trucks about 1980...
  20. Scott Danforth

    1993 OMC 5.8 EFI Idle problem, runs on throttle, too rich

    Your boat motor is not OBD1
Top