Search results

  1. Scott Danforth

    merc 3.0 carb low speed idle setup.

    Start about 3/4 out from seated on the idle mix. The rebuild kit will have instructions
  2. Scott Danforth

    97 SeaRay 175 project boat hull weeping question

    It will cure hard in high heat...... If the temp is high, it will even cure in the bucket
  3. Scott Danforth

    VP 4.3GS Carb Tuning Vacuum Port?

    That may push your needles open
  4. Scott Danforth

    97 SeaRay 175 project boat hull weeping question

    It remains tacky for the next layer, or until you apply gel (and then spray a coating of PVA to final cure)
  5. Scott Danforth

    Prop size 1989, Mark cruiser, 3.7,18.9

    And what RPM are you spinning at WOT
  6. Scott Danforth

    Fuel Tank Access

    Every boat was hand built, so each will be different. Use a stud finder
  7. Scott Danforth

    VP 4.3GS Carb Tuning Vacuum Port?

    If the float is too high, fuel gets pushed thru the boosters As Lou asked, are the floats cutting off flow?
  8. Scott Danforth

    Need Cover caps on support rods

    Google Bimini top fittings.... You will find what you need
  9. Scott Danforth

    1999 SEI186 Fuel Tank and Fuel Sender

    Guys, this is an old thread, read the rules on posting in any thread older than 90 days unless it's your own thread
  10. Scott Danforth

    Antiseize on sparkplug threads

    Snorted beer out the nose
  11. Scott Danforth

    1987 Larson 120 motor removal

    Look at the videos in the Mercruiser forum stickies
  12. Scott Danforth

    BassTender 11.3 Plastic (Polyethylene) Jon Boat Transom Repair Question (Bass Tender, Bass Hound, Bass Raider, Pond Prowler, etc.)

    Most likely it's the soft rubber breaking down. Plastic and rubber only survives 5-10 years before breaking down
  13. Scott Danforth

    5.7 Mercruiser Dies on Idle

    Look at the lower shift cable adjustment in the stickies
  14. Scott Danforth

    VP 4.3GS Carb Tuning Vacuum Port?

    This are not externally adjustable You can remove the bowls without pulling the carb if you need.
  15. Scott Danforth

    5.7 Mercruiser Dies on Idle

    Look at your lower shift cable and the shift interrupt switch
  16. Scott Danforth

    got a new boat 1982 cherokee bow rider

    Define a while. Based on the thread, it sat for 3 years. I would drop in a new impeller after 3 years and lube it with water soluble glycerin such as KY jelly
  17. Scott Danforth

    Exploded impeller alpha 1gen2

    Start at the thermostat housing and start removing hoses. You will also need to back flush the power steering cooler
  18. Scott Danforth

    Quicksilver 3000 direct replacement options

    Just buy another 3000
  19. Scott Danforth

    BassTender 11.3 Plastic (Polyethylene) Jon Boat Transom Repair Question (Bass Tender, Bass Hound, Bass Raider, Pond Prowler, etc.)

    Get thru-hull fittings with rubber gaskets
  20. Scott Danforth

    How do I hook up a power receptacle that's only hot when engine runs?

    I would run the relay off the alternator output with a diode. That way if you have the key on listening to tunes, the cooler won't drain the battery
Top