Search results

  1. Scott Danforth

    how hard would it be to ?

    Sell what you ha e and buy what you want. Will be a tone less work and significantly cheaper Cuddy's less than 22' are useless. Not enough room to sleep
  2. Scott Danforth

    1958 Mercury Mark 28

    Oldmercs also has parts, tools, etc
  3. Scott Danforth

    Removal of alluminum boat fiberglass top cap

    Most likely the prop is cast bronze and unless it's missing, much cheaper to repair
  4. Scott Danforth

    Reattach cap to hull

    4000UV would be my go-to
  5. Scott Danforth

    Starter or solenoid ?

    My guess is corrosion or bad connection. Clean all battery connections including the mounting pad for the starter
  6. Scott Danforth

    Old I/Os = Money Pits?

    Any boat under $5000 is a project. A $700 boat is definitely one needing work
  7. Scott Danforth

    Should I buy this 1973 Evinrude 65 triumph?

    Make sure to service the raw water pump
  8. Scott Danforth

    1958 Mercury Mark 28

    You have to replace the impeller as step 1 of resurrection of any outboard. So service the raw water pump
  9. Scott Danforth

    Can't get over 2k on water

    Your issue is in your post. Compression 90 psi or below is a core motor to be properly rebuilt. Have the block bored/honed, get new pistons and rings
  10. Scott Danforth

    Yep, another prop question!

    Until you get a WOT run, you don't have a starting point. When you get the motor broken in. Change the oil and then go for a WOT run. From there you can dial in the prop and not before
  11. Scott Danforth

    V-Hull Vs Flat bottom Speed

    Sculling crews can get almost 15mph
  12. Scott Danforth

    69 and up 25hp - a good choice ?

    You're looking for a 55 year old motor that was designed to last 15?
  13. Scott Danforth

    Replacing 5.0 oil pan, gasket, bolts

    Yes, you can buy GM parts from GM
  14. Scott Danforth

    V-Hull Vs Flat bottom Speed

    With the same 4hp? The same speed. Until you get enough HP to get the boat in plane, you are at displacement speed
  15. Scott Danforth

    Oil Change and Gear Oil Change issue . Can you help ?

    No such animal as marine oil SAE 30 is SAE 30. Go to Walmart, tractor supply, Napa, carquest, etc.
  16. Scott Danforth

    Old I/Os = Money Pits?

    Most IO boats are fiberglass and neglected and look good long after they are rotted to the point of being unsafe
  17. Scott Danforth

    How To Determine If Motor Is 305 Or 350

    96-97
  18. Scott Danforth

    1980 39' Mon Ark PCF (Swift Boat)

    Welcome aboard. Get a manual for the engine and drive from the respective companies Most boat information is generic. What information are you looking for? If you are looking for a manual for the boat, keep in mind there are no manuals for the boat
  19. Scott Danforth

    Whats your system for dockside mooring covers

    Agree with above Canvas must have waterproofing reapplied every 6-12 months (even sunbrella). 303 fabric protector
  20. Scott Danforth

    How To Determine If Motor Is 305 Or 350

    Port side will have displacement cast in the motor. Casting numbers on block may be easier to get to
Top