Search results

C Sun distributor machine?

West Marine is hiding behind a Chapter 11 so they don't have to pay the 850million they owe their vendors and suppliers while giving themselves a large bonus A good friend of mine is trying to get $2M that they owe him If you find any of the execs from West Marine, feel free to punch them in...

The stamping on the front of the block is meaningless in marine applications. The serial number is on a tag riveted near the starter

And forklift motors and trash pump motors. The 3.0 liter starting in 1991 is a built in Mexico industrial motor sold by GM for a bunch of applications The motors were sold to Mercruiser, OMC, Volvo Penta, etc. The motors were the long block, water pump, flywheel and starter with the ignition...

Banks are insured by FDIC for $250k per account per banking establishment.

Please re-read the rules you agreed to Regarding your boat, start with following the troubleshooting guide before firing the parts cannon It's never the coil, and doubt it's the trigger coil. Check the basics with a DVM

Look under the drive where the hose and fitting is on the H-frame. Replace the fitting, pull the drive and replace the O-rings that seal the H-frame pivot shaft

Usually trailer axle alignment is adjusted with heat and a brake press by physically bending the axle

Cookie wheel in the die grinder Cut out the rot Weld in new aluminum

For a boat that just sits, a small 20 watt panel with a battery tender is all that is needed

Ted, did you share the real world test with the NA? they like the feedback. do the hondas have a limited output like some other motors until they get thru the break-in period? that may explain your lower than expected WOT. or you are slighly over-propped, considering you dont have the bilge...

You will have to call Livorsi

Foam is for flotation until you get to the 8# and 16# density foam

Carnac says 33 gallons isnt fuel dock prices $6/gallon in Boston?

there is no fuel economy on a boat unless you have sails or oars......

August 29th is right around the corner

Yes, that is a carter electric pump

With the rainy season here. going to make new canvas bows for the boat. been meaning to for about 3 years now. getting tired of water pooling in the canvas. really need to sand the boat down and repaint it.

thats great. last I remember, you were splitting the sail boat cap from the hull. did that ever get finished?

thats just a pedestal. you need to mount a seat to it