Search results

And thanks for letting us know!

Better try a different compression tester.

Clockwise. Right now it's somewhere in between. Once it's in the correct position, leave it alone. To repeat Racerone, lift the high idle leaver on the motor turn key while pushing in. Pushing in the key activated that primer. Report back what happens.

End play ...side to side movement of the piston moving it with your finger. If it moves a strong eighth.....it will need honing and rings.

End play on pistons? Cylinders scored?

@ 60lbs ID say it's done or head gasket. Others might say it's "ok" not sure on this one.

Your smart..... And no wing nuts!

I buy the cheapies....polarity protected so test it before you put it in.

You can mount the kill switch on your dash if you want but you will have to wire it into the box. Post Pic of control box, if it's a white or black box with a red plug on the end of the harness it should have a spot for a man overboard switch.

Probably the vst or something but best to go to the E-tec web site and read their posts or make one ... Google barnacle bills E-tec and it will show up. I wouldn't run this motor until it's fixed

Bring it up to the speed that it will just run and do a cylinder drop test.

If everything tests ok then it has to be something is grounding. Follow wires and check for shorts....or it could be grounding in the control box. This assumes no vro

Tim, Pretty sure no manual primer on that model. I have one and it's a choke. I'm guessing weak spark, still something in carb/float or plastic carb parts.

Everyone probably knows the next question, spark jump 3/8 of an inch with a nice blue crack?

Ok ...hope this helps you.

Yes, that would top the day!

I'll give you some pictures of mine in a few right after I finish my steam bath. Throttle handle is easy to take apart just don't loose any parts.

Yes. Do you have a primer or a choke....also do you know the difference?

Electrolysis.....add or clean/replace zinks. I'll send a picture later of someone who didn't and this 90 was in fresh water. Bottom of powerhead to the bottom of the gearcase destroyed basically. Is this an aluminum boat? I personally coat the hole clamp system with 5200 before mounting the...

Shoot... Sorry, tired last night. That's the t&t colors. My bad. Your colors are correct.