Search results

Yes it does. I wouldn’t have one that didn’t I’m not going down for someone else’s crime spree.

This is hands down still my all time favorite gun. 1972 Browning hi power. It fits my hand like a tailored glove and I’ve runs 1000’s of rounds through it with zero hiccups.

Nice they had the records to give you that info Sometimes you have no clue what you have due to a special order.

I went flying with my daughter the other day. Oak Bluffs harbor is empty. The boating season is over😔

That bolt looks to be broken off above the lower unit so its likely is not holding on to the lower. Wooden wedges are your best bet at this point. Gat after it.

Agreed get the tab out of the way. Not sure what you have for tools but a few things to try on the cheap would be to use a dremel and carbide cutter to grind in some new flats, cut a slot and try a hand held impact driver, hammer on an old socket or drill just the head off and leave the stud to...

Do you or a friend have a welder? You could weld another nut on the rounded off head and give that a try. The heat that’s applied helps as well. As for the other broken bolt you would be surprised how much holding power that has even without the head on it.

Picatinny rail

I recently got the sig 1911 emperor scorpion bb pistol with full blow back for some back yard fun and it has certainly delivered lots of fun.

The weather has down right amazing around here. I won’t even see the 30’s until next week then the 20’a roll in soon after that. It’s been 25 years since I’ve seen the harbors freeze up.

As a kid I always wanted to paint my room with the Pink Floyd Prism but mom just wouldn’t give in.

To me the first step would be to determine the cause of no compression and the cause of the failure. A complete tear down would be my first step starting with the head on the failed cylinder to be sure it’s not just a gasket but with zero compression you may not be that lucky. If that...

Hope it was good for all. We made it through the day with no problems. Kids almost got into in once but the dog got between them and saved the day😂

Do a compression check to determine its health and go from there.

Mark the hub and the prop and take it for a spin to confirm or deny the prop is slipping.

Agreed with above. IR guns are dirt cheap and give you a good pice of mind. I have a $60 Kline and $8 harbor freight IR gun and they both read the same.

I have had good luck with the Harbor Freight tarps. They don’t see a lot of sun but they definitely see a lot of wind. I get 3 or 4 years out of them.

See ya

Engineering plan. For a credit car captain that adds another $30 bucks worth of time to the shop bill. 😂

I do love a hood smoked cheese. When I was in China I ate a lot of stuff that I had no clue what it was. There was one thing that was just amazing and it turned out to be smoked tofu.