Search results

Anyone know if a Hourston 20’ top could install on a an old Sangster 19’ boat. A lot of adapting? A little? Won’t work?

Oh I’m hearing about it. She is educated from watching and was quite a help with the first one. Now she thinks I’m nuts.

Haha we think alike.

I was trying to talk myself into a rebuild not necessary. A little floor patch and done..

Thanks for the answers. The boat is a 7 hour drive away. Good price. Been there done that with four previous similar rebuilds and looking at this one. From experience pretty much know soft leads to rot somewhere. So I'd have to drive down their to have a look and check it out. I am a little...

Looking at a 21' boat with a soft spot on floor about 24" square 3' in front of the transom on the port side. Boat has a pod and motor that when moved up and down shows no movement in the transom and pod which appear to be rock solid. There was a seat above the soft spot that has been moved that...

Will try the two separate lines off the separator with separate primer balls. if that gives me issues will go to the selector switch. Thanks for the input.

I guess we find out on the lake.

I have run my 5/16" line from separator to my 9.9hp Honda and my 3/8" line to my Merc 125HP from separator. Both with primer bulbs. Do the primer bulbs have backflow preventors built in?

I probably have the answer but will ask. I have a merc 125hp and Honda 9.9 kicker coming off one fuel tank with one line into a fuel/water separator and one line out to a primer bulb then tee'd to a 5/16 line to the kicker and 3/8 line to the 115 HP. My kicker stalled a couple times last time...

Goes off at cruise speed. New thermostat just installed, have a leg extension kit so took drive off and checked impellor( was new) its fine. Poppet Valve I changed the diaphragm, rest looked good. And changed installation method of the ext. kit and outdrive to make sure I have a good seal with...

Chris1956 I am checking out water pressure gauge’s to buy and will probably go that way, but had a couple water temp gauges, sender was cheap so trying that to get to bottom of temp alarm going off.

May have found it on net tan/white stripe goes to trim unit?

A couple more questions my third pic shows a tan and a tan/white stripe wire coming off my remote cable at the engine. As they are also coming off the remote control at the front. From what I’ve read the tan wire is for my sending unit to the gauge at the helm. So I run it from the sending unit...

Thanks briangcc appreciate that. Now I can remove it and put in my new sending unit. And will look around for the alarm sender.

I don't think it overheated only that the alarm went off. Non stop alarm. Shut off motor for a bit end of alarm til it runs some more. So the plug in the engine is for the alarm? In the video below the guy takes it out without explaining what its purpose is. Plus no wires to it, how does it...

I did try looking up the posted diagrams but they won’t open. My motor 1996 merc 125Hp had the heat alarm come on last couple times out. Have checked impeller all good, and replaced the thermostat. Before I hit the water again I want to get a temperature gauge hooked up. My motor presently has...

Does that amount of water seem excessive to you and others? And that's a remove the powerhead fix?

Here is another two videos from each side. Again water only coming out the front of drive behind mounting bracket. I will guess its normal excess water coming out when running in a barrel. Didnt see water outvof there on a hose. water. Would that be right. Reason I'm asking is temp alarm going...