Search results

Did you clean the carb? Did you do the primer assembly? Fuel pump? all should have been in 1 kit. What is your compression? that screw on the front of the carb is not the idle screw. It is the low speed mix screw and should be se around 2 turns out.

Or the key is not in the impeller.

How do you have a 130-140 degree temp with a 143 degree thermostat? How is 160 overheating? Definitely good luck with your motor.

I agree good luck with your motor.

Go to the AOMCI for help Discountmarine.com

To use the starter get some jumper cables. Attach the positive to the cable stud. Now touch the negative to the starter housing. To use the remote starter switch attach the positive jumper cable to the battery side of the solenoid. Attach the - to the block somewhere. Now Attach your switch the...

An impact gun will not turn the flywheel.

Good luck with your motor.

Did you put oil in the cylinders before your compression test? Thats more compression than it left the factory with. What happens if you pump the primer ball on the fuel line when that is happening?

What is your compression and spark test results? Is this a good fuel pump or a Chinese knockoff?

Try pumping the primer ball when that happens, if that helps could a fuel pump. You also need to do a compression test, and a spark test.

Put the throttle tight to the stop and ignore anything on the throttle. If it does not start easier that way then try opening the low speed screw on the carb an 1/8-1/4 of a turn see if that helps with starting. Good luck with your motor to much nonsense being thrown around on this post. The...

Because people are adding to much information and it is getting muddled. Try the throttle first. Float level is hold the carb upside down and set the float to level. Do not change any gaskets. the fact that it idles well says the head gasket is probably good. If you want to check do a...

Good luck with your motor

Put a timing light on the motor when it is doing that. Your transition ishould be at 1800 rpm not 2500. What is your compression and spark needs to jump a 7/16 air gap.

What about the tps?

You do see the pic of the 9.9/15 hp Johnson right? Or the fact he said it's a 1996 in the picture?

Try water snake,Newport Vessels or go plus. You have a Chinese trolling motor that is marketed under several names

Get a factory manual. Put up a pic of the side of the motor with the linkages.

Turn the throttle until it stops. Leave the choke on until it actually starts then turn it off. If it has a manual primer pump it once or twice and leave it out until it starts. Don't know what you mean by heats up?