Search results

Start with a factory service manual and then disassemble the lower unit and all internals.

Since power was traveling on the wrong highway, it likely got to the voltage regulator. Check it out.

Jim, so sorry your life experiences have been filled with sheisters and crooks.

A whole lot less than overheating your engine.

oil plug seal, blue fiber washer 12-191833

Could have been a 1973 model, but built before November 1, 1972, then it wouldn't have a HIN. Otherwise, top starboard corner of the transom. No secondary location back then..

Drop the lower unit and make sure the key is in the impeller. Then install lower unit and make sure the water tube is inserted into the water pump housing. Put motor in lake or tub of water, make sure water pump is submerged in water.

Well I have. I guess you just haven't seen everything in this world. I've also had to move an 80# kid from the bow seat to the middle seat. If the bow is nose down, the motor may not have the power to push it up.

Is there too much weight in the front? The 25 may not be able to lift the bow if the bow is too heavy. You may actually do better with both tanks in the rear. Try it. Also you could replace the kicker tank with smaller tank, or only put a gallon or two in that tank. Or just use the...

So you don't hook it up backwards. The primer bulb won't work if fuel hose is connected wrong.

Drill hole. Insert 6Y7-83540-80-00 and attach retaining piece Connect the wires Or… look at the manufacturer’s website under “technical support “.

If you can still read the screen on the garmin, there are a few drinks left in the kesslers bottle. If you can’t read the screen, the bottle is empty.

Any $99 fish finder will have a temp sensor. What is so important about this if you are not fishing?

You need a wiring harness with 2 relays for the tilt.

All normal to me except the flywheel moving.

bottom hole is the bilge drain. left hole is the livewell drain right hole is the livewell inlet which should have a screened cover over it to prevent debris and weeds from entering. Looks like the screen fell off or broke off like most of them do. The plug in that hole means either the cheap...

Surface gaps in All my mercs.

3M 4200

Key components to identifying the year: 1 Switchbox with bullet connectors (not a pair of cd modules, or a terminal strip with screw connections ) A square Mercury fuel pump ( not an "8" shaped pump ) A fuel enricher. If you have all of the above, you should have a 1994-95 model If you have...

It’s an allen head.