Search results

Are there any inspection plates in the floor?

Not uncommon for a coil to get hot, but if it burned you then too hot. May have a short in it. What Scott said is the reason I decided not to go that direction.

Your still growing!

I had thought about doing that on my 1980 scorpion but ended up staying with the points.

May as well use it if it works. I didn't know that it existed.

Would he still have a resistance wire with the electronic ignition conversion

Yep, the layup was a bit off, a limber generally is much cleaner than what you posted.

Never seen one that looks like that. Is the bulkhead rotting.

Fuel pressure is around 5 psi . And how far into the carb did you go.

Sounds like a problem with the carb, that's where I would look, maybe a gunked up fuel tank.. try running it off a portable tank.

Need to see it without the boat.

I suspect it would, I used a plastic cutting board to make pads for my cam cleats on the primary winchs.

looks like you need to re-bed the deck hardware, make some new mounting pads for the running lights,

You will need a lube pump fitting and adapt it.

Stop by your local HF store, pic up a racing jack. Jack stand, and electric impact driver.

They need to be opened up and then dry the hull out. They Will return if the laminate is still wet no matter how much epoxy you put on them

I don't think I'd want an electric back hoe.

Versus what, medium or large 1/4 inch. ..:)how it tracking now.

amazing what a good nights sleep will do. I see it just fine today. gel coat has trouble bonding to epoxy. I would use the epoxy and just paint over it with the bottom paint.

I must be blind, what needs fixin.