Search results

I made a long set of jaws for a 2 jaw puller, to get the forward gear race out. I also had to machine a split driver for the pinion race. If you are interested, I can post pictures. The tools are available at a high cost from merc.

PICO also makes them 7168-0-C

not the engine for the inexperienced. MAKE SURE THE PLUGS ARE THE EXACT NUMBER!!!!

it is possible the shift shaft was not aligned and the shaft was driven through the block. I have welded a few blocks from this

Sierra 18-7914

Outboard Control Shift Cable "throw/stroke" specs. Hi Gents Has anyone come across shift "throw" specs for outboard controls? I can't seem to find any documentation. Thanks

Does anyone know if this connector can be purchased separately? Thanks

Does anyone know if it is possible to purchase this fitting separately from Merc. It seems only available as a line assmy.

Anybody recognize this rubber item found in the bottom of a optimax 225 engine compartment?

when in neutral, the cam should look like this.....

Could someone be so kind as to posting the measurements of this backlash tool for Merc. Thanks

look how bad I have to adjust the tabs to get a level float.

Thanks GA boater. I actually have that manual, but the specs don't apply. Thats the issue. The spec I need is for a 1987 not listed. Thanks for your effort.

1987 Yamaha 30ELH Can anyone find the float setting for this model? I have searched everywhere to no avail. The floats look way low from level. Don't know if this is correct, as they look low. Thanks

Easy to do with a couple of springs, piece of plate and a vernier caliper. You have to calculate the bottom jaw into the equation.....

two easy ways....

iboats 18-0871

Makes no difference. They are common in the pack