Search results

Just replace every few years

Don't go there, will be a long con-vo The brass fitting that screws into the block is the standard 1/4 NPT. The NPT changes it to the Merc thread which uses the Blue plug or Hradin Marine SS plug

Most drill up thru and then use flat blade screw driver or easy out

Replaced mine with Hardin Marine stainless steel ones, they will not break. Blue plugs are ok but need to be replaced every 2 to 3 years

Should be Gen 6, boat is 1999 but bought in 1998. Who knows might be older. Maybe have a look at the plate in it

Motor came out today This is new, a tray under the intake. Have not seen that before, guess we will install in rebuilt motor. Injectors go out tomorrow to Smitty's in Michigan

Looks like you need to move a couple hoses. The 2 coming off the very top section of the thermostat housing should go to the rear elbows

Using your part number "YSC10103100C" the part comes up at a few different places. Are you looking for a cheaper place or any place? If cheaper I cannot help

Moved your thread and closed the other

Howdy and welcome aboard Need manual #2 for the motor and Trans. This manual does not cover the control Look in the link below and try to find your control for parts breakdown and then search for that model manual. The bad is its so old that even finding the model the breakdowns are not very...

So long as water is moving the AC should work unless there is something wrong with the AC. Doesn't need to be forceful but can be

Not to bad for a 40 year old motor

It's possible the the pump has gone bad, the impeller may also be a little stuck. Not all manufactures install a strainer. If your in fresh water many times it's a good thing to have but not needed. If you can hear the pump run but there is just no water being moved. Take a shop vac and put...

This one https://skiboatpartsonline.com/Coupling-Puller-Tool

Bravoits can only be seen with transom raw water fitting removed. If not removed this is will not be seen behind fitting

Hey, I have twin V8 Verado and with one software button I can make it louder. Not saying it's sounds anything like a Tower, but it does change the sound, and yes I might be hard of hearing :unsure:

Managed to get the prop shaft to break loose from the coupler. Lots of pressure was used and there was a loud bang when it released. Worked off and on for a few days and got no where. Bought the right puller and some 6.5 inch grade 8 bolts and it came loose. Motor comes out tomorrow if all...

My first comment is because you said "no start" Thinking we need to get it started first. Since it does start and now hard to shift the drive might be damaged. Pull the drive to see if the cables move smooth with drive off. Then shift the drive and see if it does ok moving the shift foot...

Over 65 with a 21 footer, might be a bit of chin walk

Disconnect the shift interrupter switch on the shift plate and see if it will start If it does, try to readjust it.