Search results

Thanks! So you glued the transducer right?

Appreciate it, I might take off the current pitot cover and make a bigger hole to put both wired through

Thanks, I'm mainly using this for a fish finder so I'm wondering if that will impact my capabilities of sensing fish deeper in the water.

Also you won't happen to have a picture of yours would you?

Great thanks! So it doesn't have to be in the bilge where it's closer to the water?

Which one do you use for your installation? I'm trying to see if I can put one in the bilge. The bilge is just so deep and hard to reach.

Would love to see a picture of that! Do you happen to have some? I will go with your route.

I see, thanks!

Ah ok, so I suppose that was factory right? I doubt I can use that same Speedo hole to route both the hose and the transducer wire?

Where in the hull would I put it on the sx 175? Do you know where a good location would be?

I'm leaning to the Stern Saver method. So do you guys just drag the line inside the boat with the line exposed?

Thanks! Where would you route the wire through to the front panel instruments? I'm not quite sure if my sx 175 has any holes in the transom to route it through.

For the depth finder sensor are you using the same hole by chance?

Ah ok thank you so much! Had no idea what that was, now I know. I'm trying to install a fish finder, but don't want to drill holes. Any suggestions? Would love to install one.

Hi, I bought an used 2001 glastron sx175 hand it as what looks like a sensor on the bottom of the transom. Does anyone know what this is? I don't have a fish finder or depth finder anywhere in the boat so I'm curious as to what this is. Thanks!