Search results

requires pulling the drive which is part of the annual PM service

yellow should have a red stripe if OMC followed the proper wiring color scheme

iboats wouldnt open on the home 'puter this morning. Firefox update was being pushed. so I went to task manager, killed the process and once the updates were installed, good to go. may be same on your end.

I'm running Firefox and chrome depending on which device

Then I apologize

What does this have to do with the OPs thread? Please do not hijack threads

As stated above. You need a new lower shift cable and you need to adjust it properly

Only 14 years past the typical service life

Confirm the Welsh plug serial number and the tag coincide

Nowhere do you post compression numbers. Start there Then check the contents of the fuel filter for pure fuel

Don't know. Get firmware and software updates about 3x per week at work. The last was all the MS office 365 and Edge (don't personally use).

Nowhere in the factory manual does it say it's OK to try to draw AF up thru the muffs

There is a MS update that was pushed thru recently

Im only getting 7 years on fence sections anything rot proof or mildew proof after 2004 is not.....that is when they quit using arsenic in things like marine vinyl, marine foam, treated lumber, etc.

you can buy a 2-post garage lift for about $2k that has the safeties built in. you do need 8" of concrete slab to anchor it with. a 4-post lift is a bit more.

submersion pond pump that hangs from a float to keep ice from forming around your boat by keeping water flowing

First, Welcome aboard Second, assuming its a Perko. https://www.perko.com/help_guides-wiring_a_battery_switch/ Here is the schematic from their site

It's not the same.

EFI can't add power, never could. Changing engine architecture does Your 400 and 283 blocks are old 2-piece RMS motors which is a 20 year step backwards. Useless in this application. Vortec heads recommended The 142 will most likely interfere with the marine T-Stat housing. You can't use...

Open deck block would be hard to warp. Most likely a non-mercruiser gasket