Search results

Yesterday I was out testing the engine, run fine for about 30 minuters, I was starting to think that the problem was gone, but no. Lost all power, could not get the boat to plane. 200 hp turned into 2hp. A new 10 micron filter installed. Fuel rail hold dont drop to 0 when turned off, have to...

Testa done now with these results. Compression 1. 8.2 bar 2. 8.5 bar 3. 8.2 bar 4. 8.6 bar 5. 8.1 bar 6. 8.5 bar Fuel pressure Only pump rinning 37psi Engine running on idle 36psi Engine running 2000rpm 34psi Checked with a timing light that I have spark on all cylinderns. Spark advance on...

I have a strange problem with my engine. Sometimes I loose power, the 200hp feels like 5hp even with full throttle. If I put it in neutral I can rev the engine and think it sounds good. But with gear in there is no power. And then all of a sudden things are working, and I can get the boat to...

Thanks for the information. I just bought this engine and thought it look strange.

Is it just for ventilation?

Can someone tell me where this hose is supposed to go? As you see it's a T on the oil hose from main tank to small tank on the engine.

Found the fault today. Screews holding the bearing on the piston rod had come loose on one rod. So the screew went into the crank case wall and stopped the movement. The bearing itself is trash. Lucky the engine was at idle when this happened.

I was idling the engine home on a hose. Have started if a few times the last week, and thought it run fine every time. Running on pre mixed fuel even though engine have autolube. This is a engine that I bought recently and have not been out on the lake with so far. Suddenly the engine stopped...

I'm sorry I see now that I need a peak voltage adapter to measure the voltage from the coils. Have to get me one of those.

Thanks, this is what I need. My cranking RPM is 220, manual say it should be over 250. First voltage from stator should be minimum 85V, I only get 15V. And next voltage should be minimum 25V, I only get1.5V. A new starter is ordered today. Hopefully that's the issue here.

Have not get it started. But battery is good.

It a 225A ETOL from 1989

I have 12v in on red wire to cdi when I crank the engine. But I understand that it's alot more to it. Can you tell me more about what to measure?

I recently bought this engine. It has been sitting on a boat at the previous owner’s backyard for maybe 10 years and not used. And of course I can not start it. Have new plugs but almost no spark on them. Have only seen a very week (almost invincible) spark on two of the six cylinders. There is...

Here is the whole head with the hose plugged. I noticed that the colour of the cylinder part don't match head and intake. Someone might have replaced it back in time. There are two hoses going between intake, and one from intake to cylinder 2, should it be four hoses in total?

Been looking everywhere but I can not find any connection for this small hose. Could you provide a picture maybe?

I have only run it at home on a hose.

I have been looking but can't find other end? My motor is from -88. An -89 and newer dont have this connection?

I recently bought this outboard and started it for the first time yesterday. Runs like crap and air comes out of the little broken hose. Whats wrong here, should it be connected somewhere?

I’m having two problems here with this motor, think they might be connected. Problem 1. I cannot get the engine to idle properly, have done the link and sync process. Cleaned the carburetors and make sure there getting fuel. Spark is good on both cylinders. When giving throttle there isn’t...