Search results

The grid runs at 60 hertz ( cycles / second ) and when too much power is drained off it slows down.-----Too much power going in , it speeds up.-----Green power is politically correct.----Green power does come cheap.-------I read that in many countries they are planning more dams to generate...

Flywheel only fits one way.----Timing does not change by removing and putting the flywheel back on.

This stuff can all be calculated.------The big variable for solar is the amount of sunlight.----The big variable with windmills is the changing nature of the wind.----Been in the control room where the system was asking for a 50 megawatt reduction in power as folks went to sleep.---Grid was...

Many of us would agree that the radiator does not appear to have enough capacity.-----So we all have to wait for the report on the 20 minute ----FULL LOAD--- testing.

Pushed shift rod all the way down to try and get forward ?

I have a Mac 10 outboard ( not operational ).------Air cooled rotary Wankle engine by ----" Sachs " from Germany and assembled in Italy.-----Paid very little for it.

Air will work it's way out.----The motor is turning.----Is the pump turning ?-----Are you testing BEFORE putting it back into the midsection ?

Throttle plates are CLOSED at idle.------Your manual will explain synchronizing of throttle opening and ignition advance.----Read it and understand it before making any adjustments !

Reed stuffer.======A means to reduce crankcase volume.-----Done to get higher crankcase compression.-----Done to get better and more complete scavenging of cylinders.----Used on some Johnson / Evinrude 135 / 140 HP models back in the 1970's

There are no vacuum ports on this 2 stroke motor.

Is the motor running while you try and shift ?-----Or if not running are you turning propeller while shifting ?------These lower units are not considered robust .----What does gear oil look like?-----How did it shift for you last season ?

Normal to see water from tell tale after lots of cranking.-----There is no reason for the motor to be " hard to start " after carburetor work.-----Time for some trouble shooting.-----Post your compression values.

Ge said that he had it all figured out.------Need a video of a 20 minute full throttle test on a boat at 50 kilometers / hour.

That has to be drilled in the correct position to line up the throttle grip.-----The OP is busy making a replacement I would say.

So for a 5 kilowatt system how big ( surface area ) would the panels be.---A 2 kilowatt system would be how big ?

Major damage on the front may be difficult to repair.----Involves the shifting bits and a bearing housing that accurately positions the forward gear.

So is your motor a tiller motor ?-----Pictures show a remote motor.----------Been converted to remote ?------You totally looking this up wrong.----go to ----evinrudeparts.ca-----And find the part numbers for this motor !!-----Look on the cylinder / crankcase page.

Any other pictures of the damage on the front of that housing.?

They say that in many gated communities the old folks use electric golf carts.-----You need a 6 pack on board.-----This is so that when your batteries run down you can ask a new friend to plug in for 1/2 hr while you share stories of your grand kids.

Your location ?---Where how have you looked for these parts ?-----And if you have the part #s you will be able to find parts via ---E-bay and other places.---