Search results

  1. studlymandingo

    Alternative anchoring method.

    Watch this video clip on an alternative anchoring metod: http://whassup.com/hahaouch/anchor.mpeg
  2. studlymandingo

    Lobster Diving in the Keys

    It's almost that time!!!...Lobster sport season in the Keys. Two days of bug hunting intermingled with fun and friends in the aquamarine waters of the Florida Keys! Any other iboats folks making the trip???
  3. studlymandingo

    Lacing a T-Top Photos

    A couple of months ago I posted the question of how to lace a t-top. My latest boat had a canvas top that was installed with a bunch of zip ties. timmatthews sent me a drawing of how to do the lacing. I finally got around to lacing the top today and I took some photos; so maybe it will be of...
  4. studlymandingo

    Mariner Rebuild cost.

    Much cheaper to do it yourself. More than half the cost. Parts won't be too expensive.
  5. studlymandingo

    Trim/Tilt motor problem.

    I am helping a friend diagnose his yammie outboard. It is an EFI 6 cyl. The trim/tilt has stopped working. It started yesterday with an intermittent problem, now it is completely inoperative. I disconnected all of the wiring to the motor, as actuating the switch sent voltage to both the...
  6. studlymandingo

    Year of Outboard

    I am helping a friend repair the Trim/Tilt of his outboard. I am trying to identify the motor in order to get parts.<br /><br />The numbers on the outboard are:<br />S225TXRV<br />and:<br />624 UL 100116<br /><br />Thank you for your help.
  7. studlymandingo

    Idle Adjustment on V-6 150

    I am still trying to massage the idle on my 1986 150 EXLPTO Mariner. I was reading through my Seloc manual regarding the "type E" carburetors before going out to make the idle adjustments as I have noticed some inconsistencies in the plugs (some look a little wet) so I thought an idle jet...
  8. studlymandingo

    What do I do in this situation???

    I just purchased a 1.5 amp onboard battery charger. I just cracked open a beer and sat down to look over the manual before installing the unit, and there it was... Under personal safety in bold print it says: Do not install or use battery charger while tired or under the influence of drugs...
  9. studlymandingo

    Couple of loose wire photos here...

    There are two wires that go to nothing on my 1986 Mariner 150 outboard. One is a red wire with a white stripe; it has a rubber plug in the end of it like it might be disconnected from the factory.<br /> <br /><br />The second wire is a tan wire that has a crimped on connector on it. It is...
  10. studlymandingo

    Spark Gap Tester...KCLOST???

    I just bought a spark gap tester, I'm not sure if I need one; but after reading several posts by KCLOST, I decided it would be prudent to have one in my arsenal. I like tools anyway! :) <br /><br />I have a Mariner 150 and the idle is a little rough, doesn't seem to be a miss though and never...
  11. studlymandingo

    Electric Choke / Enricher Valve Inoperative

    I have a 1986 Mariner 150. After doing a decarb with SeaFoam (I doubt there is any relevence here), the electric choke or enricher solenoid is not working. I discovered this after an overnight camping trip. PITA to say the least, fortunately I had a couple of gallons of gas in a spare can...
  12. studlymandingo

    2 Birds with one SeaFoam

    I did the decarb with SeaFoam today and noticed a secondary benefit. Mosquito fogging. <br /> <br /><br />Took her out and ran WOT for a little while. I definitely have a smoother idle now.<br />I am going to see if the neighbors will chip-in for a couple of cans per week, I'll just run some...
  13. studlymandingo

    Ready for a new prop--Dhadley Kenny?

    Currently I am running a Rapture 14 1/4 X 21 SS prop on my 18' Center Console with a 150HP Mariner. I have Smart Tabs on the boat and I get on plane satisfactorily. Right now I'm getting about 43MPH GPS at 5300RPM. After reading all of the posts where the Rapture seems to be referred to as...
  14. studlymandingo

    cross-pin stuck on tilt shaft Any Ideas WillyB?

    Today after returning from diving, I noticed some fluid on my 1986 150 Mariner lower unit. Upon closer inspection, I found the retaining ring and washer for the tilt shaft were at the top of the shaft, not in the cylinder where they should be. I moved them back into their proper position in...
  15. studlymandingo

    Air Filter for Mariner

    Thanks to this forum, my Mariner outboard Serial Number: 0B144478 Model Number: 7150746 has been identified as a 1986 EXLPTO 150HP. There is no air filter on the motor, and I have been doing several searches on the internet, and have yet to come up with a source. Does anyone make an air filter...
  16. studlymandingo

    Lobster Sport Season

    Anyone here heading to the Florida Keys for opening of Lobster Season this year. It's in the last week of July, and it is always a blast! Last year the group I was with all got the limit both days, one of the guys caught a nice Mahi on the way back in. Talk about a feast!! I would highly...
  17. studlymandingo

    Painting Lower Unit--What to use?

    Well, I created some more work for myself. I recently traded a couple of boats for an 18' Center Console with a 150 Mariner OB. The Fiberglass Clamshell was sun-damaged pretty badly to where there were glass strands sticking out on top. I had originally decided that I would do a light...
  18. studlymandingo

    Installing complete brake system

    I am contemplating installing brakes on my boat trailer which has none presently. I have an 18' Center Console with a 150 Merc. I would like to be able to tow the boat with a Ford Escape. I have a full-size Dodge Pickup that I tow it to the local ramp with. This works fine for running around...
  19. studlymandingo

    Ramp Etiquette

    This would be a good post for those new to boating. Today, I was testing out my rig with a new set of Smart Tabs (Great Investment). There is a boat ramp about 3 blocks from my house that puts into Tampa Bay. I frequently use this ramp, and generally people are courteous. Today however, I...
  20. studlymandingo

    Run to Bimini

    Anyone made the trip to Bimini from Florida?<br /><br />I'm considering making the run and was just wondering if anyone here has done it, how long it takes, etc. I can cruise at 35-40.
Top