Search results

  1. M

    Looking for a carb????

    Motor is a Evinrude 150.<br />Model# e150stlcrd, ser# j0430842.<br />The fuel inlet fitting on the primary carb is cracked. It is molded hard plastic tight 90 degree elbow on a brass fitting. Can't seem to remove. If I could, I probably could rig a fitting but just in case, does anybody know...
  2. M

    Query For Schematic

    Are your electrical/electronics experties limited to boats?<br />I am attempting to design a timer (clock)that will initialize upon sensing a load and terminate when load has stopped. Similar to an hour meter, but must be indiscriminant.<br />Any ideas?<br />Voltage would be 115 vac+- and amp...
  3. M

    Boat Won't Plane

    18' Starcraft aluminum. 150 hp Evinrude.Full throttle launch achieves 51 mph @ 5000 rpm in 7 seconds (yup it's fast scared the s*** outta me), but the bow won't come down for about 3 minutes. Got it trimmed all the way down. Motor is mounted at the correct height. No jack plate. Spinning a 14...
  4. M

    No Battery

    My report on my first test with this boat.<br />http://www.iboats.com/cgi-bin/ubb/ultimatebb.cgi?ubb=get_topic&f=1&t=000299&p=2 <br />Got to the ramp ok. Checked the drain plugs and primed the gas. Disconnect the straps and ready to go.<br />Not enough water to roll off. Too shallow.<br />I'm...
  5. M

    Designing A Hardtop

    I am thinking of installing a hardtop on my 18' Starcraft but I don't want to pay $1000.00+. <br />Was thinking about using 1/4" polycarbonate mounted on rubber mounts canted towards the bow to reduce drag and push the bow down (I have power trim so I think I could compensate) ,structural...
View older results
Top