Search results

  1. B

    Shift cut out switch

    What will happen if shift cut out switch is not working or misadjusted?
  2. B

    Initial start up

    5.0 chevy, Alpha one gen 2. Installed new impeller. with muffs on and water running several minutes should I see water exiting drive before I start engine? Thanks
  3. B

    Water Temp gage

    I am installing new digital gage. Can I use the existing sending unit ?
  4. B

    However

    After much work on boat that was supposed to be done during winter I finally put it in water. However I did not connect( Alpha 1 gen2) small tube on frt of outdrive that connects to lower unit. Boat is in water. made short checkout trip approx. 10 minutes. What should I do?
  5. B

    trim "up" inop

    Alpha one,Gen2 ​12v leaving switch. 0v at blue coil wire ​Jumper 12v to coil on relay. relay working correctly
  6. B

    Came too far for problems now

    Background: 5.0 mercruiser replaced heads w/ Vortec. new intake, rebuilt carb, installed thermostat (was missing), checked impeller (replaced last july) . ​I hooked muffs but did not see water exiting behind prop. Is this normal? or does tstat have to open for water to exit. ​Just want to make...
  7. B

    water pump

    installing new impeller ect on apha one gen2. ​the rubber block on rear (propeller side) of case. is this installed with step up (upper drive) or down (toward prop) Thanks
  8. B

    Deck trim

    trim? I am replacing the carpet (not good for fishing) with vinal flooring. Where can I purchase trim, aluminum or plastic to cover exposed edges around floor hatches for e.g.
  9. B

    Identify hole

    First of all thanks to those who replied to my recent posts. I am 67 years old and recently bought my first boat (93 23' cutty w/ 5.0 and alpha one/gen2 drive).My question is while replacing the outdrive for painting and impeller replace I noticed a hole on starboard side between two top studs...
  10. B

    Cylinder heads

    1997 5.0 vortec heads. Are port and starboard heads interchangeable?
  11. B

    What does this do

    swapped Vortex heads and 2bbl manifold onto earlier 5.0 SBC. What is purpose of hard flex tube that connects from intake manifold to exhaust manifold
  12. B

    electric head

    Thinking of installing electric head on my boat. Can the holding tank be installed higher than base of toilet?
View older results
Top