Search results

  1. R

    1976 75HP Tach Question....

    Hi: Ordered a tach today that is adjustable up to 20 poles. I believe my motor has a 12 pole stator set up? Which wires will I be using? It sounds like the choices are white, black and purple? Thanks everyone. I reviewed several posts and then became confused on the # of poles (12 vs. 20)...
  2. R

    1976 Chrysler 75HP Recommendations on Fuel Pump or Carburetor cleaning solvents

    What do you use to clean the fuel pump housing/check valves and also the carburetors on these 2-cycle outboards? I've noticed some folks use WD40 while others suggest regular automobile carburetor cleaner. I guess I'm concerned about the carb cleaner being too harsh??
  3. R

    '76 Chrysler 75 HP--No tilt-trim okay

    Hi: I am trying to revive an old 75HP chrysler. Got tilt/trim motor to run, but it will not tilt after trim is all the way out. Motor runs, but no action relative to the tilt function--trim appears to work well. 3 wire unit. What should I try next??? What type of oil is recommended?
  4. R

    1976 Chrysler 75 HP Trim/Tilt-Motor not working

    Hi Folks: I'm working on a 1976 Chrysler 75 HP and the trim and tilt motor is not working. I have bypassed the switch that has been referenced in this forum and the results are the same....no clicks, sounds or movement (no smoke, fire or sparks either..that's good!) What do I do next? I...
  5. R

    Kill Switch Chrysler 1976 75hp

    Hi All: I know there's been a ton of kill switch posts, but I have a unique situation--I think? I'm rigging an old Glasspar with a 1976 75 hp Chrysler outboard (757HB). I broke the ignition switch while it was in storage, so I have to replace it. Additionally, I also want to put in a kill...
  6. R

    Buying a motor for parts?? Good idea??

    I'm thinking about picking up a mid-70's 105hp for parts (very cheap). The current motor I'm working on is a 1977 75hp. Would there be many interchangeable parts? Both are 3 cylinder---wondering about ignition parts, lower unit, starter, etc. Just wondering if others have had successes or...
  7. R

    1977 Chrysler 75 hp Exhaust Snout

    I'm needing an exhaust snout for my Chrysler outboard. I just purchased this motor and the previous owner said it wouldn't idle well w/o fluctuating rpm. Could the lack of this snout contribute to this problem? Does anyone know where I can get the snout and the two bolts and the washer? I...
  8. R

    1991 Mercury 200Hp Offshore-Starting Difficulty

    My first Post! This engine has been hard to start for several years, even after a professional carb rebuild 2 yrs. ago ($600+). This past summer a mechanic came down to the dock and helped me start it after the primer bulb would not get hard. He indicated that I might have a stuck anti-siphon...
View older results
Top