Search results

  1. A

    OUTDRIVE TRIM Question

    Hopefully im posting in the proper area, if not i apologize - I recently was just waking the boat up from the winter and making sure everything is working properly. The trim on the outdrive goes down great, but only goes up for about 2 seconds and stops. If i use the TRAILER TRIM it will bring...
  2. A

    alcohol stove ?

    So i have a electric/alcohol stove...the electric aspect works great. The knobs for the alcohol end seem "frozen". anyone run into this or have an idea for a fix...thanks. its on a 1990 25ft sea ray...if it makes a difference.
  3. A

    cleaning compound for inflatable tubes

    i recently bought a used hard bottom dingy...it is a bit weathered and the tubes are very dirty....soap and water worked as much as its going to. does anyone know of a good compound or chemical to really clean the inflatable tubes. thanks for the help.
  4. A

    marine stove troubleshooting

    So here I am with issue number 2. I have a sea ray 250 1990. The alcohol stove on board is not working. The knobs to turn alcohol section on simply don't turn and the electric end jusat doesn't turn on. Ill be taking it out this weekend to work on it. Any ideas thanks.
  5. A

    Marine Head Question

    Not sure where to post this question so i'm going with it here. i have a 1990 25ft sea ray. Has a built in head (not porta potty) I go to pump the toilet and nothing happens switch the out valve and pump nothing happens. I get absolutely no pressure. I checked the on off valves and they are in...
  6. A

    sea ray or bayliner

    Well I need some help. I have two boats lined up. A 1990 sea ray sundancer 250 w/454 motor and trailer. Going Ford 7500. Then there is the bayliner cierra 2355 1994 5.0 merchant also with trailer going for 6500. Both boats are loaded and run well. Any advice would be helpful. Which would you buy?
  7. A

    225 Mariner Tilt & Trim Question

    Ok, so this could be an extremely dump question but i have to ask. I recently was out on my boat and the tilt and trim got stuck in the up position. Needless to say i had to use the MANUAL SCREW to lower the tilt and trim enough to get the motor to catch again. The tilt and trim worked fine but...
View older results
Top