Search results

  1. Larry E

    AMP gauge reading

    What might it mean if the AMP gauge reads 40 on the chg side of the gauge at all times? Larry E
  2. Larry E

    Take a look at this please

    I am working my way through the electrical system on my 74 Seaswirl. I am having an issue with the starter cranking with the key in the momentary position but then when the key is released the starter keeps working. I have to remove the battery cable to get it to stop. When I reinstall the...
  3. Larry E

    Ignition switch or what?

    I got my neutral switch installed and WALLA the motor turns over like a champ. But wait a minute it will not stop cranking when I release the key. I have to disconnect the battery to stop it. Then when I hook the battery back up it is OK till I turn the key again. Ignition switch or slave...
  4. Larry E

    HELP I need to find this neutral switch

    I need to find a neutral switch for my OMC throttle (see pictures). The ones I do find are out of universe costly like $299 (are you kidding me?)I have a part number which is 172123 on the switch, and 980798 on the throttle. Any help appreciated... Larry E
  5. Larry E

    Motor height adjustment

    What is the adjustment necessary for the front of a GM 2.5 motor. I know how to do it just not sure where it should be initially. Thanks Larry E
  6. Larry E

    OMC tilt mechanism

    Not sure if this is the right place to post this but here goes. Got the new transom seal installed so now I am moving to the tilt mechanism. I have a new motor, new hammer coupler but the tilt worm gear will not move. I removed the motor and put a screw driver to the mechanism and it will not...
  7. Larry E

    Transom seal replacement

    Re: Transom seal replacement That is great advice. My boat is orangy red also so Permatex Copper it is...
  8. Larry E

    Transom seal replacement

    I am going to be replacing my OMC transom seal tomorrow. What kind of sealent should I use between the rubber and transom? Larry E
  9. Larry E

    Weird hole under floor leading into bilge area

    On my 1974 Seaswirl there is a hole that is under the rear edge of the floor and leading into the bilge. At first water came out of the hole after I removed the glob of silicone someone had plugged the hole with. Is this hole supposed to be there or is it supposed to be plugged? Thanks Larry E
  10. Larry E

    Throttle Assy needed

    I need this throttle control assy for my 1974 Seaswirl Ranger 16 foot. I do not need the cable assy. If you can help let me know EDIT Thanks Larry in Creswell Oregon
  11. Larry E

    Help with dash board wiring

    Re: Seaswirl manual Re: Seaswirl manual Take a look at these two pictures and tell me which is the correct way the arm and roller should be. When I took the throttle assy apart is was like the first picture with the arm outside of the slot.
  12. Larry E

    Help with dash board wiring

    Re: Seaswirl manual Re: Seaswirl manual This was a great help...Now I am suspecting I have a bad neutral switch in the throttle assembly. I am wondering if the arm that activates the individual connections in the switch is any good. The arm does NOT move freely so I do not see how it can be...
  13. Larry E

    Help with dash board wiring

    Seaswirl manual Seaswirl manual I am restoring a 16ft 1974 Seaswirl Ranger and need to find a manual or a wiring diagram for the boat. Any ideas? Thanks Larry E
  14. Larry E

    Help with dash board wiring

    Re: Help with dash board wiring One last question regarding this dilema. I understand what each terminal is for now could you tell me what colored wires go where? That is the crux of the matter. Also every wiring diagram I have seen calls for a "yellow/red stripe" wire from starting switch to...
  15. Larry E

    Help with dash board wiring

    I am presently restoring a 1974 Seaswirl Ranger with OMC and GM 2.5 motor. Prior to me buying the boat someone tried to rewire the dash board and did not get things back where they were. Would it be possible for someone reading this to take a picture of the wiring on the back of the dash if you...
View older results
Top