Search results

  1. S

    1984 Lund 16 ft, 70 evenrude steering cable part

    The cable is stuck it is rack type with the 4 bolts holding the rack to the steering colum. I cant seem to see part number on cable. Can somone help me with part# to order here or whole new steering system for boat and motor? Are all the cable motor ends that go in tilt shaft the same length and...
  2. S

    1984 Lund 16ft 70 evenrude 13ft steering cable part#

    Can someone help me find a steering cable (for sale/part number) here on iboat site. it is one of those old cheep rack and pinion types with the 4 bolts hooking the rack to the steering cable.
  3. S

    1986 60hp evenrude tilt trim part number

    Anyone know tilt trim part number for 1986 65hp?
  4. S

    1988 60hp evenrude gear case oil

    What's the capacity 80 90 lower unit grease ok
  5. S

    Sync 76 tower carbs

    Is there ports on the mk carbs you can use a motorcycle carb sunk tool on.
  6. S

    weird socket to tighten lower unit prop shaft carrier

    bearing carrier retainer nut tool for inline 6. Anyone see where one might buy one. What torque, I don't wan't to f@#$ gears. Here is the nut http://www.ebay.com/itm/like/182205498641?lpid=82&chn=ps&ul_noapp=true
  7. S

    Top gear case screw

    The former owner screwed it in so I cant get it out with screw driver, any ideas. Would you use Impact Impact Screwdriver or would you be to afraid of busting case.
  8. S

    Choke primer

    My 1988 My Evinrude starts very hard when cold but runs fine after that. Can you please give me proper sequence for starting. I see it has electric primers instead of manual chokes. Do you pump bulb, set fast idle and then hold in key and turn together until it starts. Is the electric...
  9. S

    ebay backup propeller 24ft 60HP Evenrude

    What should I shoot for, just will use in emergency on Mississippi. Is this way to small? Boat propeller aluminum 10x14 OMC 380-228 1.19" DIA X 3" length In my town and $10
  10. S

    Johnson JW21E

    Just picked one up. Probably 1966. Probably been setting a while. What maintenance should I do? Any old Johnson manuals on line?
  11. S

    1988 60 HP Evenrude Tilt Trim Install

    Finally got my pontoon boat. It runs fantastic, but has no tilt trim. I want to add it. Nothing on youtube. There are many on ebay for sale. Do you have to remove the motor? Can you give me any directions, hints, or point me to something on line?
  12. S

    1994 20 FT. 40 HP Bass Tracker on Missississippi

    Anyone know about rivers? Is 20 FT. 40 HP Bass Tracker on Missississippi safe for use? Is that enough power? Looking to buy one.
  13. S

    1978 merc compression test after sitting 8 years

    Turns over, what should i do before taking compression check. Have not bought it yet, $150 for motor and controls was set up for pontoon which I need. I know how to check for spark and oil in lower unit and bent prop shaft.
  14. S

    1984 20ft sylvin pontoon and 25hp

    Is the motor big enough to push it. Want to use it on Mississippi some times.
  15. S

    1988 20ft 60hp evenrud

    What do you think it is worth. Good shape, but slipted in Lacrosse WI on Mississippi. No trailer dilivered to my camp ground were I purchased a slip They want $2900
  16. S

    Filter screen in carbs

    1. Do I have to remove the carbs to remove clean the screens. If they and the bowls were clean would you leave them alone' it's been years? 2. Any other fuel filter anywhere. 3. I suppose you have to remove the hole front/face plate plate and wiring to remove carbs for rebuilding? --basic steps...
  17. S

    90hp tower ss# 5031148 1978 I think slide clutch

    Can you pull the drive shaft and carrier without removing the lower unit or will you break something to do with shifting. I cant figure out what moves slide clutch back towards the reverse gear or into neutral. Any help extremely appreciated.
  18. S

    Got prop carrier out 90hp tower part question

    So after I pulled the shaft and all out the cam follower on the end of the shaft after the clutch dog fell out. Manual says something about 3 small balls used for bearings under the cam follower. Is this true, wish I had part number, merc dealers parts guys are dumb as doorknobs. If you had one...
  19. S

    90hp 78 inline 6 winter use

    Thinking about fishing walley on Mississippi river this winter/pre spawn 30 degrees Will it run and start. Never tried before. Shuld I just forget it?
  20. S

    Johnson Model J40EL0 SS# 07016743 Ignition (1985 probably)

    Is this UFI? Is this basic capacitor discharge ignition like in a motorcycle? Engine is 2 cylinder with two coils. Can someone give me a brief description of how this works or point me to a spot I can read about UFI. I know about spark plugs, Coils, Stater (points/electronic equivalent), so...
Top