Search results

  1. M

    3L core plug

    Is the core plug at the rear of the engine (behind flywheel) the same size as the ones in the side of the block thanks
  2. M

    5.7 mercruise battery draw

    i have a 1992 5.7 mercruiser and it has had the alternator replaced with a delco alternator with a spark arrestor kit installed in it.There is a .34amp draw comming from it (battery will go dead after a few days of sitting)when you unhook the excite and sense leads load is gone the diode in...
  3. M

    good vhf entenna for under $100

    i am looking for a good quality vhf antenna under$100 something with decent range i have a cobra mr 45 d radio
  4. M

    top speed stingray hydrofoil

    i was wondering if there is any speed to be gained by removing the hydrofoil off my gen 2 drive.its on a baja 204 i am told that they hurt top end speed would like to hear other people's results with and without them.ran it last weekend with it planning on removing it this week and trying the...
  5. M

    1409 edelbrock carb jetting

    i just installed a new edelbrock 1409 600cfm carb and edelbrock performer intake and vortec heads on my 4.3 mercruiser and i installed the 1485 needle and jet kit edelbrock recommended the engine has a lean condition on the bottom end has anyone else had this issue with this same setup.
  6. M

    4.3 mercruiser roller cam

    does anyone know what year mercruiser started using roller cams in their 4.3 and what the profile is on it thanks
  7. M

    1991 4.3 mercruiser alternator

    The alternator stopped charging on my baja 204.checked all wiring is ok.The alternator that is on it is a 55amp mercruiser part #98555.Does anyone know the part # for any replacement alternators from napa.I prefer to buy from them as i am an auto tech and have a wholesale account with them thanks.
  8. M

    baja prop swap

    I have a 1991 baja 204.It has a 4.3 mercruiser 4barrel. right now the prop on it is a 13.75 dia 21pitch. I would like to have more bottom end power for getting on plane faster without sacrificing too much top end speed thanks.
  9. M

    unhooking shift rod on 1989 johnson 110

    i am removing lower unit and just wondering what is the best way to go about unhooking the shift rod.It looks very hard to get at . thanks
Top