Search results

  1. zero lash

    Mercruiser injector harness plug sequence

    I have 2000 Mercruiser 502 Mag and I am not sure what injector plug goes to which cylinder. I have looked up a few diagrams but my wire colors don't seem to match up. I do see numbers that I cannot find on a diagram either PED
  2. zero lash

    5.7 TBI advanced timing

    I rebuilt a 5.7 the boat runs and starts great but to do so I had to advance my timing. When I have set the correct timing using timing tool and procedure for my boat that i got directly from mercruiser. My boat mph drops significantly. If I advance it runs great. My question is do I need to...
  3. zero lash

    Replaced my trim limiter bravo drive and no power at connection

    I have a 2000 Baja. I replaced both the trim sensor and trim limiter. The trim sensor worked I was able to adjust the gauge. The limiter did not work at all. When I when to adjust it from turning the puck to adjust it it did not work. So I switched the wires did not work. I checked the fuses no...
  4. zero lash

    HELP W/ Cam upgrade 5.7 electronic fuel injection

    Motor is a freshly rebuilt 5.7 liter motor w/ Vortec heads EFI. It was bored 30 over. Only upgrades I have done is upgrade plugs and wires and thru hull exhaust. I really like to upgrade to a performance cam. Has anyone done this before or have any recommendations. Thanks
  5. zero lash

    **PLEASE HELP**98 sea ray 210 potential water in hull

    Water came out of holes when I removed bildge. Where do I start.
  6. zero lash

    dont read

    How to check remove the water and inspect
  7. zero lash

    5.7 TBI perfomance issue on a rebuild 14.5x17 prop

    I have a 98 sesearay 210. I had bought it with a cracked block and put a rebuilt motor in it was bored 30 over and i upgraded piston in rings to get alittle more compession. I also installed a thru-hull exhaust from the side. I have set the timing at 10 % BTDC and it idles fine my top speed is...
  8. zero lash

    1998 Searay 210 motor shut off and wont turn over

    I was out Sunday cruising along and motor shut off. It was running 2000 rpm and 160 deg. (1998 Merc 5.7 160 hours on it) I had it towed back and noticed a brown milky material coming from pvc. I went todo compression check and could not get it to turn over just clicked. I tried to turn crank and...
  9. zero lash

    1998 Python Venom help with resto. Either to do or not to do.

    Ok found an 1998 Python Venom 21' ft bowrider it has 250 hours on it. It has Mercruiser 350 Magnum and Alpha 1 drive on it. Motors starts and runs good. I know that the coupler is bad and needs to be changed (thats why he is selling) I have done a couple before and not worried about that. What I...
  10. zero lash

    Need some advice on buying a used Python boat

    I have run across a 1999 21 bowrider Python boat had a 350 and has 250 hours on it. It looks in fair cond. I have never heard of these boats and can't find much info on them. Like what sort of problems they have. Anyways he said there is a seal of sorts that is located between motor and drive...
Top