Search results

  1. S

    Amsoil full synthetic oil?

    Has anyone used Amsoil full synthetic oil at 100-1 in a premix outboard? Thanks,Steve.
  2. S

    Splines on Force outboard?

    Mercury Sportjet has 13 splines on shaft that goes into the crankshaft.How many does a Force outboard drive shaft have? Thanks,Steve
  3. S

    Sportjet flywheel guard?

    Anyone have a flywheel guard for a 90 or 120 Sportjet they would sell? Thanks, Steve.
  4. S

    Impeller nut size?

    What size is the impeller nut on a 1999 Sportjet 120 XR2? This is the bigger pump. Thanks,Steve
  5. S

    Sportjet piston and rod.

    Looking for a 1996-2000 Sportjet or Force piston and rod for 120hp or 95hp. Thanks,Steve
  6. S

    Sportjet 120 piston and rod

    Looking for a 1996-2000 piston and rod for Sportjet 120 or 95. Thanks,Steve.
  7. S

    Sportjet pump removal

    Has anyone ever had the plate that sits on top of the sportjet pump on the inside of the boat refuse to be removed? I have tried pry bars,liquid wrench on the studs and nothing.The plate is loose in the front but the rear of the plate by the exhaust will not break free.I have placed a car jack...
  8. S

    Shorelandr trailer for Sugar Sand boat?

    I bought a 1999 Sugar Sand Heat jet boat and I believe it is on a Shorelandr trailer.The ID number has faded away on the frame of the trailer. I need new u bolts for the leaf springs and Shorelandr can not help me with out that number to look up the part.If someone has a Sugar Sand sitting on...
  9. S

    1995 120 Sportjet crank

    Any one have a 1995 120hp Sportjet crank in good condition they would sell? Thanks, Steve.
  10. S

    Water filter on Sportjet

    The sportjet engines are outboard power heads. The water passages in the engines are rather small and if you get enough junk sucked up into them you can block water flow and overheat the engine. If you cut in a raw water strainer in the hose before it enters the exhaust manifold you can catch...
  11. S

    Sportjet pump bolt?

    Any one have a stainless M10x100 bolt for a 1995 sportjet pump. It is the one that goes through the stator and wear ring. Thanks,Steve.
  12. S

    sportjet 120

    Can you use a 1996 crankshaft in a 1995 block? The manual shows the bore and stroke and mains are the same. The rod journals are larger on the 1996 crank.So if you use the 1996 rods and pistons and the crank will it work in a 1995 block? Thanks,Steve
  13. S

    Muffler on a 120 sportjet?

    Has anyone put a muffler/waterbox on a 120 Sportjet? It would eliminate hot exhaust gas on the steering and reverse bucket cables and get away from blowing off ride plates.
  14. S

    94 yamaha 40 hp lower unit

    Looking for a lower unit for a 1994 Yamaha 40 hp long shaft. model 40tlrs. Thanks, Steve
  15. S

    1973 65 hp johnson ?

    I have a 73 65hp johnson I bought cheap. It had a cracked lower unit so I bought a 73 lower unit housing off of Ebay and swapped in the original parts. I put in new seals,o-rings and a new water pump impeller. Put the lower unit back on and it fired right up. I ran the motor in a large tub of...
  16. S

    1973 65hp power head - 1980 75 hp

    I have a 1973 65 hp Johnson long shaft with a bad lower unit. I'm looking at a 1980 75 hp Evinrude short shaft with a jet pump that has a broken block. Will the 65 hp power head bolt up to the 1980 mid section? Thanks, Steve
Top