Search results

  1. J

    Leaking still after bellows replacement. Help please

    Had water coming in and replaced bellows and just took it out for first time after and still getting water in? Any other places water could be getting in? Seals or o rings etc....Posting a few pics and try posting video
  2. J

    Starter wiring please help

    I got the new mini starter and can’t figure out wiring. I know the two big red wires go on the big post. I have a small purple wire and a red and yellow wire that’s together. Took pic of old wiring from old starter. Tried that and not getting power. Swapped the two small ones around and...
  3. J

    Starter help!!!!!! Omc cobra 4.3

    Are you suppose to use smaller bolts in length. Starter is about 1/2 inch from snugging up when bolts are tight???? Any suggestions??? 4.3 omc cobra
  4. J

    Missing seal / gasket??

    So I pulled the outdrive and there is no seal where it comes apart ! Isn’t there suppose to be one where the 6 bolts are where you take it apart ??? had water in both bellows but don’t see any cracks in bellows .
  5. J

    Pulling outdrive question????!!!

    What gear does omc cobra go in to remove the outdrive to inspect/ replace bellows and gasket?? Thanks in advance for any help.
  6. J

    Hose under engine open??? Please help

    Is this hose suppose to be down here open like this? New to inboard outboards. Here is a picture of where it connects to engine and where it lays under on floor. I’m trying to figure out where I’m getting some water in bildge!
Top