Search results

  1. K

    SEI Alpha 1 Gen 2 lower ratching noise (with video)

    Good evening all. I recently installed a new water pump and shift shaft bushing. Now, I have ratching in the lower unit that seems to come from the shift crank, spool or propeller shaft. I've attached a video for reference. Is it possible the shift crank or something shifted when I pulled the...
  2. K

    Teleflex 73742 trim gauge vs sender resistance values

    Good evening, I recently replaced my starboard trim sending unit with a sierra unit and cannot get the gauge dialed in. Symptoms are that gauge is pegged up with key off engine off and key on, engine off. This seems normal for this gauge as I verified other internet pictures show the same...
  3. K

    5.7 slave cylinder wiring

    Gentlemen, As previously discussed i have a 1998 sunesta with an older 1988-1995 5.7 in it. I'm getting close to being done with the wiring and have a question on the slave cylinder wiring. Questions below: 1. I do not have any wire coming from the "I" ignition terminal and from doing some...
  4. K

    Mercarb 2BBL vacuum hose?

    Hello, Thank you for all the help thus far in getting my boat correct. I have the carb off to clean it, and this vacuum line was capped. Should it be, and if not, where should this be connected? It was capped on my 5.7
  5. K

    Mercruiser 5.7 with V6-14 TB IV module??

    Good morning, I have a 1998 Sunesta 232. It currently has a 5.7 Mercruiser and TB IV ignition in it. I removed the DIZZY to drill out some broken cap screws, and it was running before I did this. I believe the engine was swapped out by a previous owner. I have verified the block is from a 1987...
  6. K

    Alpha 1 Gen 2 limit switch bracket

    Good Evening, I'm in the process of installing both the limit switch and the position switch. When tightening the bracket against the transom plate, it goes around both halves of the limit switch cables to make the water-tight seal as they pass through the transom plate. What I'm noticing is...
  7. K

    Mercruiser Oil Gauge pegged KOEO

    Hello, I have been troubleshooting the oil gauge (P/N 73180), which is pegged at 80 psi, and am at my limit for troubleshooting, so I need assistance from the forum if anyone could. Below is what I have done to T/S thus far to troubleshoot. 1. This is the original condition when I bought the...
  8. K

    Not permitted

    MOD edit: not perminted thanks, Ken
  9. K

    Alpha I Gen II Gear Oil Leak

    Hello, So I have had a gear oil leak coming from my outdrive that has accumulated. and as it leaks, it fills up the orifice around the lower shift shaft and leaks out of the weep hole on the lower outdrive. Today I finally removed it to start troubleshooting and rebuilding. I did not conduct a...
Top