Search results

  1. D

    No water coming out of the exhaust on muffs

    2000 Bayliner 1850 Capri 4.3l Mercruiser Alpha One Gen 2 Recently i’ve replaced the water pump on the lower unit and took the upper unit off to check bellows and u joints, i’ve also replaced the thermostat (the boat has only been in fresh water) got everything back on now and let it run for a...
  2. D

    Outdrive will not go back into transom

    2000 Bayliner Capri 1850 4.3l mercruiser alpha one gen 2 Pulled my drive to inspect the bellows and u joints, now when putting it back on it gets stuck about an inch away from closing up, shift linkage is in forward and lined up correctly as well, tapped it with a rubber mallet too and still...
  3. D

    Bolts for water pump are rusting

    2000 Bayliner Capri 1850 Mercruiser 4.3l alpha one Gen 2 Replace my water pump a few months ago and while changing the oil I noticed the bolts for the water pump seems rusty, is this a common issue and what should I do? Replace bolts with Stainless steel one?
  4. D

    pieces of something when taking lower unit off

    Bayliner Capri 1850 Mercruiser 4.3l Alpha one gen 2 Was taking the lower unit off to replace the impeller and i noticed 3 piece of what looks like a rock and 1 piece of aluminum casting from somewhere.
  5. D

    Cut wire on top of coil pack

    Bayliner Capri 1850 Mercruiser 4.3l Alpha one gen 2 Was pulling trim wires for my new trim sender and limiter and notice a cut wire on top of my coil pack. Trying to figure out what it was, boat seems to run fine.
  6. D

    Gear Lube lines plugged with bolts from previous owner

    Bought my 2000 Bayliner Capri 1850 w/ 4.3l Mercruiser Alpha 1 Gen 2 drive last year, been doing some maintenance on it recently and looked and seen the gear lube reservoir was empty, I filled it back up and the next morning there’s gear lube on the ground, I look a little closer and I see a bolt...
Top