Search results

  1. A

    Should I be O.K. with this winterizing

    Don't know exact model number but it is a new engine 06. Big V-8 mpi. Has the block drain in the front down at the bottom where where all the water drains from. I guess it is called the manual signle point drain system. I got the engine nice and warmed up and drained it, no problem there...
  2. A

    cd player and starting engine

    i have one battery and one engine, small boat. if i have my cd player on when i start my engine will that hurt the cd player. I know if i trim the outboard up and down it shuts the player off because it takes the voltage away but then i can turn it back on. I'm just worried about if i start...
  3. A

    flywheel magnets

    force, 1989. 85hp 856L9C. Magnet strip came off of the flywheel. can i glue that back on with 5200 or is there something that i have to use?
  4. A

    battery question

    I have a 32' silverton. last summer i had lots of battery problems because i hooked everything up incorrectly and killed my batteries. So i now have four new batteries, two cranking and two deep cycle. I also have two battery switches, one switch for a cranking and deep cycle, another switch...
  5. A

    over heat but still has water coming out

    yamaha, carbed. 150's or 200's i forget, they are 6 cylinders. the port engine over heated but there was still water coming out of the pee tube or whatever it is called. I know it wasn't from running anything over beacuse i tilted the engine up and there was nothing there, let the engine cool...
  6. A

    electric fuel pump question

    merc, elect. fuel pump carbed. 5.7L what causes the fuel pump to turn on for a second when you turn the ignition on but turn off after about a second of running. I know it shuts off because of no oil pressure at the oil pressure switch but how does the fuel pump get the voltage to begin with...
  7. A

    i think it overheating

    yamaha T9.9EXHA the thermostat area gets to about 60 celc. then the thermostat opens up and the temp there goes back down to about 50. but the cylinder areas are reaching about 190 farenheight. is that normal?
  8. A

    yamaha 200txrs sputtering and stalls

    yamaha 200txrs not sure the year, carbed. 6-cyl. will run for a bit but pops and sputters like it misses on a couple of cylinders. Then after doing that for a bit it will just stall dead, will start right back up though. At first i though it was carbs because in middle pair while running i...
  9. A

    no start

    merc 454 trs drive, not sure model number as block was changed in the past and there is no number, not too sure about the year either. Carbed, Thunderbolt IV with module on riser. While the engine was winterized i did the manifolds and risers, cap and rotor. Now it won't start and is acting...
Top