Search results

  1. J

    Tilt Ram Cap Replacement-2002 115 TXRA

    I was looking through the Yamaha catalog for a replacement cap for the Tilt Ram on my 2002 115 TRXA. I noticed they sell the whole assembly (ram, seals, etc), but not just the cap. This is the screw cap that requires the special tool to remove to get inside the ram to replace the seals. Is...
  2. J

    TNT leaking on 2002 115 2 stroke

    Had a great day on the water today until I was taking the boat out of the water. Was tilting the motor up and it was about 90% up (just to the safety lock) when it stopped. I checked the main ram and the housing was all oily. I got home washed all of the oil off, unscrewed the oil filler plug...
  3. J

    Understanding the charging system

    I have a 2002 Yamaha 2 stroke (115). I was having a conversation with my buddy about the charging system and quite frankly, I dont know much about it. I know my boat has a stater. Does that just keep the motor powered, thus the battery is only needed to start it and it runs on its own? Or...
  4. J

    2002 Evenrude FICHT 200HP twins cutting out

    We took a buddy's boat out yesterday and ran it in the inner coastal. After 20 minutes and being 15 miles from the dock, the portside motor cut out...it just cut out. It did not faulter or sputter, it just shut off. We turned around and headed back towards the dock, running about 2500rpms. After...
  5. J

    Buzzer on 2002 Yamaha 2 Stroke-115hp

    I took my boat out and ran it for about 2 hours or so. I had some issues earlier in the month (running lean) that required me to clean the carbs out. Anyways, coming into the dock today, as we were putting the boat on the trailer, the buzzer started going off. Trailered the boat home, hooked...
  6. J

    Moisture in gauges

    I have 3 gauges (just installed that have condensation building up on them. Is this caused by them being screwed down to tight or too loose? Thanks, Joe
  7. J

    Aviation Fuel in a yamaha 2 stroke

    Hi, I ran my Yamaha 115 2 stroke a week or so back and it had some hesitation in the holeshot. I was talking to a friend who is a small engine mechanic who suggested that the carbs have some varnish built up due to a long sitting period (not used in over a year) and suggested I use a high...
  8. J

    Center console reconfiguration

    the center console on my boat (in my opinion) is oddly designed and I actually lose useful space because of this. for example, the steering wheel is located to the left of the console. That is ok, however, the right side of the console (at the bottom) has a notch cut into the side of it to...
Top