Search results

  1. R

    Stator Test 40 hp Mecury

    I tested the stator on 40 hp mercury by swapping blue with blue/white on switch box. Spark changes fron 1 and 2 cylinders to 3 and 4. Does this mean stator is bad or could the problem be coming from the trigger? Original problem is no fire on 3 and 4 cylinders. Thanks
  2. R

    Enrichment Valve

    1993 Mercury 40 hp enrichment valve. Valve is good, how do I trace voltage to connector? Valve do not work when I press key switch. Thanks, Clarence
  3. R

    No Voltage

    No voltage going to switch on 40 hp mercury. Recently replaced reed block. Was turnig over fine until then. What did I do now? Have voltage at starter solenoid, no place else. Thanks
  4. R

    Reed Check

    I have the Seloc Manual for my 1993 Mercury 40 hp 4 clylinder, but it do not give a lot of detail for getting to the lower reed block. I am ready to start this task with advice from the pros. I am the one where the lower carb is blowing out fuel. Thanks!
  5. R

    Carb Blowing Out Gas

    1993 Mercury 4 cyl. bottom carb blowing out gas. Cylinders has compression and spark. Engine run on top 2 cylinders.
  6. R

    40 Hp Mercury Carb

    1993 40 hp mercury botton carb not suckng in air. Engine run on top cylinders. All plugs firing. Bottom carb has fuel in bowl.
  7. R

    Will Not Start

    At first mercury 40 hp would not idle unless I give it a little throttle. When I remove plug wires from cylinder 3 or 4, engine continue to run. Removing plug wires from cylinder 1 or 2 causes engine to die out. Engine run when giving a little throttle. I have limited skills on engine repair. I...
  8. R

    Not Firing

    40 hp mercury mariner 4 cly. no fire all 4 plugs. Was running fine, left beside dock for about 2 hrs, heavy wake, checked stator, .4 ohm, repair manual call for .16-.19 ohms. Do not have kill switch, only emergency shut off switch. What procedure shouldI follow to troubleshoot?
Top