Search results

  1. T

    Sea Pro Seats

    Hi, I'm looking for some new seats for my 2003 Sea Pro 19' Center Console. Any idea where I can buy some? mainly the center console seats but I also need the lean too seat as well.
  2. T

    Gas Tank air vent and speedometer hole location

    I have a 2003 Sea Pro 19' center console with a Yamaha 115 four stroke. I'm trying to find the air vent for the gas tank and where the speedometer hole is. I think both are plugged up. Any help would be great. Thanks
  3. T

    Ignition trouble?

    I have a 2003 Sea Pro 19' with a 115 Yamaha 4 stroke. Model F115TLRC. Just recently it takes 5 or 8 times to start when i turn the key and sometimes it will not shut off. Have to pull the kill switch to turn off. I inspected the ignition wires underneath and its clean. This just started last...
  4. T

    What Trolling do I use for a Sea Pro 19'

    Re: What Trolling do I use for a Sea Pro 19' I use this boat for fishing in the Bay and rivers South of mobile, AL. I think I'll go with a 24v 60" shaft bow mount. Thanks for all the replies
  5. T

    What Trolling do I use for a Sea Pro 19'

    I have a 2003 Sea Pro 19' and i'm not sure if i need a 12v or 24v Trolling motor. not sure if i'll use it much. Also not sure if a 12v is strong enough. Any thoughts on the wireless RF Trolling motors. What would you guys recommend?
  6. T

    How to bleed the air out of the fuel system

    2001 Blue Wave 16' center console with a 70 hp four srtoke Evinrude. I replaced the primer bulb and seemed to get some air in the line. When I pump the bulb it does not get hard or full. How do I bleed the air out? Please help...Thanks
  7. T

    Oil plug location

    I have a 2000 Evinrude 70 hp four stroke and im looking for the oil plug so I can change the oil. I'm pretty sure its on the right hand side toward the bottom but im just making sure. Any help would be appriciated. Thanks
  8. T

    Evinrude 70 Four Stroke shuts off

    2000 Evinrude 70 Four stroke Fuel injection on a 16' Blue Wave center console. I just bought this boat last week and took it out to the river and she took off kind of sluggish but I got her to plane out and she died in about 1 minute. She would start then die over and over. The primer bulb would...
  9. T

    Relay switch/solinoid

    1998 Waverunner GP760..where's a good place to buy a relay switch?..I looked on iboats and can't find it
  10. T

    PWC Yamaha Relay Soliniod

    1998 Yamaha Waverunner GP760..What's a good site to purchase a relay switch/solinoid? looked on here but couldn't find it..
  11. T

    Tilt & Trim

    I have a 1986 Monarch ski boat with a 90 Evinrude and a power tilt & trim...The Tilt cylinder is leaking fluid out the top where the o-ring is. It looks like the o-ring is dried out and brittle..I have the manual and it says to take a 1/2" breaker bar and loosen the cap but the picture doesn't...
  12. T

    Yamaha Waverunner not turning over

    We have 2 1999 Yamaha Waverunners 760. Tried to start one yesterday that has been sitting for one month w/o gas in tank. Filled up the gas tank with Marine gas and two stroke oil. When we push the start button it cranks over two times then nothing. Took out the spark plugs and it cranks over...
  13. T

    Planes out then boggs down?

    1986 Monarch fish/ski 1986 Evinrude 90 hp outboard. A while back she would run fine then once in a while she would bogg down but never die. Here recently she will come up on plane then bogg down imediatly but never dies. I checked the bulb and it's full of fuel and tried squeezing it when it...
  14. T

    Got the bog

    Hey guys, I have a 1986 Monarch fish/ski with a 90hp Evinrude out board. The mixed gas has been in there for a little while and I can't remember the last time I put sea foam in the tank. Last Sunday she would run for 5 minutes then bog down but would idle just fine, I would let it sit for a...
  15. T

    Power Tilt & Trim

    I have a 1986 Rude 90 hp and I need to replace the seals in the tilt and trim. Is it some what easy to do? Thanks
  16. T

    Help with Trim

    Hey people. I have a 16' walk through open bow Monarch with a 1986 90 hp evinrude. The trim system is mounted on the Transom under the motor and its starting to not lift/lower the motor. I was told I need to add hydraulic fluid and I'm not sure where the resivoir is located. Any ideas? Thanks Terry
  17. T

    90hp Evinrude

    I have a 1986 Evinrude 90 hp. I need to replace the Stater and not sure how? any pictures would help. Thanks a bunch
  18. T

    Bogging down

    86 Evinrude 90 hp I ran it every 2 or 3 weeks on the muffs for 5 minutes during the winter down here in Mobile, AL and it ran very well. Took it out 2 weeks ago and it ran fine. This past Saturday it would bog down but when we pumped the bulb it ran fine for a while then it must of happened 2 or...
  19. T

    Changing bulb on trailer lights

    I pulled the cover off so I could change the light bulb and there's a clear plastic cover over the light bulb. It looks kinda like a bubble over the bulb. How do I take this apart? Thanks guys
  20. T

    Kill Switch

    Just bought a used boat and the kill switch does not work. Anybody know where this hooks up to? 16' Monark open bow 90 hp Evinrude out board.
Top