Search results

  1. M

    82 Johnson control box

    Control box was working fine then all of a sudden, when i went to go full out it seems that it jump a tooth inside...took it apart and reset it all- works a few times then jumps again and i can,t go back to neutral unless i take it apart again. do i need to replace both the shift assembly #...
  2. M

    1982 70 Hp Johnson Ignition Problems

    any quick fixes for this? I can start the motor with the ignition switch but when I turn the key to the off position the motor still runs...I must choke it to stall it.any simple solutions? thanks
  3. M

    Tilt Trim From 87 90 Hp Will It Fit A 77 70hp

    What are the chances of a 1987 90 hp Evinrude tilt-trim unit to fit a 1977 70 hp Evinrude? some slight mods would not be a problem. Thanks
  4. M

    1987 Evinrude 90 HP V4 is it worth to rebuild it

    I might have a chance to buy this motor for $400.00 - $600.00 ... compression is low on all 4 cyl between 50-70. It does run. motor is clean,tilt and trim work.should I or not Thanks
  5. M

    1977 70 hp evinrude slow on take off

    I have a 1977 70 Evinrude on a 16-foot Sylvan- she starts great / idles good but when I give her full throttle, it does not rev up instantly - the revs start off slow then gradually the revs start to come up-takes about 10 secs for her to get to top speed-any clues? carbs are rebuilt-new...
  6. M

    1977 70 evinrude float drop adjustment

    could someone please tell me what is the proper adjustment on the float drop ? kit says 3\4 of an inch my generic manual says 1 1\8 - 1 5\8 thanks
  7. M

    1977 70 Hp Evinrude Carb Questions

    I have 3 questions - Float drop adjustment - The carb kit i bought says to adjust it 3\4 inch but the manual i have says 1 1\8 - 1 5\8 . which one is correct and with my kit i received a little spring for the pin float hinge do i use it, did not have one when i took it off. also my carb does not...
Top