Search results

  1. M

    89 140 Lower Mount problem

    Re: 89 140 Lower Mount problem Here is a pic,
  2. M

    89 140 Lower Mount problem

    I have a 89 evinrude 140 that had a corroded mouter mount on the STBD side. When I removed the mount I found a piece that had broken off from the mid section right above the mount. Will this cause a problem with the engine? The engine runs fine except for an idle problem where it will not idle...
  3. M

    1989 vro2 piston removal

    I have my vro2 pump disassembled because it appears to be getting weaker. All the the diaphrams look good with no cracks and the rubber all looks good. I was wondering if I could leave the oil piston out to make it eaiser for the diaphrams to pump. Is this a good idea? Do i have to put anything...
  4. M

    Twin 1989 Evinrude 140's Rough Idle & Stalls

    I will try to make this as short as possible but I have been fighting problems for a couple of months now & I have tried almost everything. I purchased the boat a year ago and there were no fuel filters on the port motor and only the in-line filter on the stbd motor. I have removed the screens...
  5. M

    1989 140 Carb Rebuild

    I am in the process of rebuilding my 1989 140 looper carbs, Does anyone have the torque specifications for these carbs. The aftermarket manual that I have does not appear to have the correct values. I also need the carb to manifold torque. Thanks in advance.
  6. M

    1989 evinrude 140 wrong jets?

    I have twin 1989 Evinrude 140 motors on my boat. While rebuilding the carbs I noticed that I had 3 different sized high speed jets for both engines (2 x 54, 2 x 50 & 4 x 47). All of the low speed jets are 41. Does this sound right? The evinrude website says the high speed jets should be 54. Is...
  7. M

    Need 1989 shift rod height

    Does anyone know the proper shift rod measurement for a 1989 evinrude 140 xl shaft (25")? From searching this site I believe it is 26 15/16 but I'm not sure. Thanks for the help.
  8. M

    2000 Yamaha ox66 stalls at 1100 rpms

    I have a 2000 Yamaha 150 Fuel Injected outboard (ox66) that stalls at low rpms. In the water it will not go above 1100 rpms in gear and 3000 out of gear. It cuts off immediatly but will restart right away once put in neutral. History, motor has had overheating buzzer sound intermittently at...
Top