Search results

  1. L

    No spark please help

    I have a 1988 mercury 100hp motor with no spark . I've changed plugs , wires & coils , still no spark . There is no kill switch on my boat either . 1988 sea ray Seville . Getting fuel as well . Any ideas ?? Thank you so much for your time ..
  2. L

    looking for 1954 evinrude part?????????

    i have a 1954 evinrude fleetwin . 7.5hp ss motor and i am trying to find the little aluminum cup that the impeller sits in. does anyone know where i can find one? or should i just buy a new water pump kit?.
  3. L

    new water pump not working please help

    Hi all i posted a month or so back about my 7.5 hp evinrude not pull starting. i got that all fixed and when it runs there is no water spray out of the exhaust . there is a new water pump and impeller in this motor . any suggestions. thank you all.
  4. L

    1954 evinrude hard to pull start

    hi i have a 1954 ss evinrude 7.5hp motor that i took apart and did a minor rebuild , water pumo, seals, spark plugs, wires , points, etc. i put it all back together and it is really hard to pull start . it feels like something is holding it back. any advice would be greatly apprecieated. thank you.
  5. L

    really hard to pull start

    Hi i have a 1954 evinrude fleetwin 7.5hp. 2 stroke. I just did a complete rebuild on it. head gasket, carb gasket, carb repair kit, impeller, points, plugs, wires etc. I put it all back together. put new gear oil in it and it is very hard to pull. any suggestions would be great. thank you.
  6. L

    torque specs

    i have a 1954 evinrude fleetwin 7.5hp shortshaft motor. does anyone know the torque specs for the head? I have an owners manual but should have bought the service manual.
  7. L

    pressurized tank parts

    I have an old 1954 evinrude 7.5hp shortshaft and i need to replace the double fuel lines and also i need the two o rings that go on the connector that attaches to the motor. Any help on where to get these parts would be great. thank you.
  8. L

    fuel line gasket????

    i have a 1954 evinrude fleetwin 7.5hp 2 stroke with the old omc gas can and dual lines. One fule , one air. Is there a gasket that goes between the two fittings(the quick relase part) gas leaks out of there when i prime it and run it.
  9. L

    evinrude pull cord

    Hi i am new to this site so i hope i can get some good information. I have a 1954 evinrude fleetwin, 2 stroke, 7.5hp. The pull cord is falling apart and got stuck inside and will not pull anymore. I removed the cover and took off the 3 screws that hold the pull mechanism on. Can i just replace...
Top