Search results

  1. Arctic 33

    1959 Evinrude Fastwin 18 converted to fuel pump- not working.

    Re: 1959 Evinrude Fastwin 18 converted to fuel pump- not working. This pic should help you with by pass cover.
  2. Arctic 33

    QD21 Fuel Pump #377927

    Re: QD21 Fuel Pump #377927 Mr High Trim was right on the money with under the carb. It is a little tight. Just finished this up a couple weeks ago.
  3. Arctic 33

    Thanks for the ideas and help!!

    I sure appreciate the help and the ideas from everyone. I believe this sure looks better. Thanks again. Chuck
  4. Arctic 33

    Do you think this will work!!!

    I had a lot of Sediment in my pressure tank. The motor is a QD-18. I ran great one day and the next day not so great. With help from everyone here, I found the glass sediment bowl full of garbage. I had a plastic tank and fuel line already. I tapped the by pass cover. The lines are close...
  5. Arctic 33

    QD-18 and pressure tank question???

    I took the boat out a couple of weeks ago and dialed in the high speed and low speed. Boat ran great. Went yesterday and the motor started but seamed to be starving for fuel. It seamed the fuel was pulsing. Alot of sneezing. The primer bulb did not want to push down. I moved the low speed...
  6. Arctic 33

    Maiden Voyage!!!

    Finally got out with my new toy. Started fine and I adjusted the high speed setting and was quite happy. Motor runs like a new one. I just don't seam to have good top end speed. The cavitation plate is about 5 inches below the bottom of boat. Would a jack plate help the top end speed...
  7. Arctic 33

    Pressure tank question?

    There seams to be some seepage around the top of the tank. It holds pressure and pumps up. Is there any thing special to know about pulling the top off and replacing the gasket or should I maybe do a conversion to single line. The motor is a Johnson QD-18. Thanks Chuck
  8. Arctic 33

    A Few Pics and a couple questions!!

    The motor has just had an impellar change. Started and idled good. There was not any fishing line on prop sahft. The lower unit oil looks good. The question is what should the shear pin on this year motor be, brass or steel. I just brought home yesterday. Will boat test soon. Thanks for the help...
  9. Arctic 33

    Just closEd the deal!!!

    Picking it up Wed. It is running and has the tank also. Going on the back of my 1972 Ouchita semi vee 14 ft.
  10. Arctic 33

    What year might this be

    I was wondering what year this is. Can you run these motor in brackish or salt water Thanks Chuck
  11. Arctic 33

    impellar change on 1956 Good year sea bee delux

    Do you have to pull the powerhead off to change the impeller on these motors. Thanks Chuck
  12. Arctic 33

    Good Year Sea Bee

    Did Gale make the 1956 Good Year Sea Bee 5? Is this a single line motor with a onboard tank too. Thanks for the info Chucks
  13. Arctic 33

    Opinion of 1958 Evinrude Sportwin

    I am looking at a motor. The motor is reported not to be frozen. There is not a tank with it. Any suggestions much appreciated. Thanks Chuck
Top