Search results

  1. V

    WOT RPM's

    The motor is a 1989 90 HP Evinrude.<br /><br />I finally solved my problem with it running higher RPM's(would only pull 4200 with hood on) with hood off(hood latch grounding out the coil). But now I have a new problem.<br /><br />I am only able to get 5400 RPM's no matter which prop I use. I...
  2. V

    question about recirc hoses

    The motor is an 1989 90 HP evinrude.<br /><br />I was examining the motor and discovered that one of the check valves was broken and the recirc hose was not attached. (Check valve on intake manifold to bypass cover.)<br /><br />How critical are these recirc hoses and check valves to proper...
  3. V

    Motor runs at higher RPM's with hood off

    When I run my 1989 90 HP evinrude I can only get 4200 RPM's no matter what the load.<br /><br />If I take the hood off I can get 5000 RPM's and if I trim it up I can get 5200.<br /><br />Some times with the hood on it will get the 5000 RPM's. <br /><br />I am still trying to figure out how to...
  4. V

    Perplexing RPM issue

    I have a 1989 90 hp Evinrude.<br /><br />I just rebuilt it, new carb kits, had a link & sync done by a shop(did good up to that point but couldn't figure it out by reading the manual.) Did a proper break in.<br /><br />When I get the motor to wide open throttle it will only pull 4200 RPM's.<br...
  5. V

    wirng adapter question

    I am pondering adding brakes to my boat trailer. The question I have is in regards to the back up solenoid and the wiring of such.<br /><br />I have a 2002 Chevy Silverado. It has a seven pin connector on it. My trailer has a four pin connector. If I install brakes I will need to install a...
  6. V

    Removing rear bench seat?

    I have an Xpress VJ 2270 and would like to remove the rear bench seat to open up more space. <br /><br />The question is can it be done without severely degrading the structural integrity of the boat?
  7. V

    help!

    You probably want to post the motor info(year, make, model) so someone can help you.
  8. V

    Which High/low Speed Orifices

    While recently putting my 1989 Evinrude 90 hp bakc together I managed to bust the hose fitting on the carb bowl. I ordered a new bowl and it arrived.<br /><br />When I went to take the orifices out of the old bowl I stripped the slots on all four. <br /><br />The high speed orifices I took out...
  9. V

    1989 evinrude 90 HP lower unit

    Just drained my lower unit in preparation of changing the water pump later this week and the lube came out cream colored. The manual says this is bad. <br /><br />What does this mean?
  10. V

    1989 90 HP Evinrude rebuild

    The motor is a 1989 90 HP Evinrude. <br /><br />I bought the motor took it out and got no power and the overheat alarm was going off. I did a compression test and all cylinders read 120-130 except for the top right which read 0. I pulled the head and there was extensive damage to the one...
Top