Search results

  1. A

    What does the trim limit KIT do?

    Just FYI it's an I/O drive. Omc cobra 5.8l. And I do understand what trim does that's not the question the sending unit that tells me how high the stern drive is stops working at about the 20% mark due to the fact that the stern drive is no longer touching the sending units arm anymore which is...
  2. A

    What does the trim limit KIT do?

    So I am newish to boating. I installed a trim sender assembly on my 1990 omc cobra a few years back. But it only reads on the gauge for the last 20% of travel down. As soon as it get past about 20% up the gauge stops working because there is a huge gap between the switch arm and the stern drive...
  3. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    Finally No more leaks. So to recap, there is two faults, one pinhole in the bottom right corner of the transom assembly. And a broken nut on the bottom right side of the exhaust flange, both contributed to the leak. It did have a small leak when I bought the boat which Was originally probably...
  4. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    In these pics I first dremeled out the pin hole very slightly so I could push some Jb marine weld through the hole and then cover outside. Let that curw for a day and the I added a layer of the 3m marine adhesive 5200 (fast dry version) should be ready to get wet in 7 hours for hopefully the...
  5. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    Ok so half the issue was the exhaust pipe obviously but I found under very close inspection a pin hole on the bottom corner of transom assembly. Wasn't sure it was leaking there till I had my daughter blow compressed air through it and I could see air flow from inside so if air is getting...
  6. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    Exhaust pipe flange was broken on one corner so I'm bleeding that was it. I got it welded and new hole drilled. Put it back on torqued to 50lbs. Really didn't feel to tight but left it at 50lbs. New oring seal and gasket sealant before seal on transom assembly flange , on seal and on exhaust...
  7. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    Still leaking but really narrowed it down. Ok so what I've done so far. New * bellows * Lower Shift Cable * tore apart entire stern drive replaced all seals and gaskets * pretty sure I did all seals and gaskets on transom assembly * new gimble bearing and seal * removed old caulking and replaced...
  8. A

    Do new gimbal bearings not swivel

    I have purchase 3 different gimbal bearings thinking I'm either getting defective or cheap China brands because none of them swivel (as a gimbal should). They spins like a bearing but it's my understanding that gimble bearings are suppose to swivel, pivot, articulate, what ever you want to call...
  9. A

    LEAKING IN FROM LOWER TRANSOM PLATE BUT NOT ROTTED

    OK so title says not rotted but Im not 100% sure that that would be the cause. I have tapped around the transom with ball pin hammer and its has solid spring and doesnt have flat sound or rotted. The fallowing is what ive done so far. Took the outdrive off and there was lots of water in the...
Top