120 1990 Force no voltage to front of boat

[dugan500]

I have a 1990 120 force . It has power to solonoid but does not have any going to ignition . It has power going into the block on the red wire leading in but no other wires . I checked all blade fuses GOOD . The Circuit breaker has power coming and going . If you jump across the solonoid ( the 2 big lugs )the starters kicks over . Neither small post on solonoid have power . THE kill switch is hooked up and all wires have not been tampered with . the bilge won't power up or the lights or anything else . No Power going forward . No power at the fuse Block . Wires going forward Have no damage or corrosion . The motor is a very low hour Freshwater only Motor . had been sitting for 2 years but no moisture anywhere . ? This one has me stumped .

 

[dugan500]

Re: 120 1990 Force no voltage to front of boat

not sure on this one

 

[contractorguy]

Re: 120 1990 Force no voltage to front of boat

Is there any power at the ignition switch?

 

[dugan500]

Re: 120 1990 Force no voltage to front of boat

no none at all

 

[contractorguy]

Re: 120 1990 Force no voltage to front of boat

I would check the main harness connector. (back by the engine). Maybe just a bad connection due to corrosion?

 

[dugan500]

Re: 120 1990 Force no voltage to front of boat

This one has no plug in conector . All wires factory direct into motor . Thanks Jim

 

[contractorguy]

Re: 120 1990 Force no voltage to front of boat

What brand of boat?

 

[dugan500]

Re: 120 1990 Force no voltage to front of boat

20 foot Maxam

 

[contractorguy]

Re: 120 1990 Force no voltage to front of boat

Outboard or L-drive??

 

[RRitt]

Re: 120 1990 Force no voltage to front of boat

one of leads at switch should have constant power.
if none of wires at switch have power then that is problem. correct method of fixing problem is to trace wire back and find out where connection is lost. could be deadman switch, could be inline fuse, could be unswitched fuse in fuesbox, could be corrodded connection, could be a million different things.

pull out manual and identify which wire should have 24x7 voltage. go to switch and double check voltage. if no voltage at switch then start tracing wire back towards battery one connection point at a time.

 

[apauto06]

Re: 120 1990 Force no voltage to front of boat

i am having the same problem but the cd coils and the coils are grounded has me stumped to i have an 88 bayliner w/120hp force