150 force

catfishwv

Seaman Apprentice
Thread starter
Joined
Mar 11, 2011
Messages
38
took the boat out today it doesnt want to idle or go very smooth at low speeds in a no wake zone. after I open her up it runs smooth as silk. I've replaced the plugs and ran a can of sea foam through it to no avail. last year 1 turn of the key and it fired up ran smooth as could be. also I had the speedometer fixed on it on a 16 ft bassboat I only get like 44 mph. last year it seemed to go fast but I didnt have the speedometer working at the time. could it be a dirty fuel filter? I'm at a loss.
 

healey8390

Petty Officer 1st Class
Joined
Nov 19, 2010
Messages
217
Re: 150 force

Well my boat was idling like crap and ran good at wot but would only turn 4000 last monday. I found out #2 is not firing and am acutally about to post a question myself. Check for spark on all 5, check the carburetors to see if they fell out of synchronization. When was the last time you did a fuel pump diaphragm?
 

catfishwv

Seaman Apprentice
Thread starter
Joined
Mar 11, 2011
Messages
38
Re: 150 force

i've never done it... does 44 mph seem to slow for a 150 on a 16 ft bassboat?
 

Robert D

Petty Officer 1st Class
Joined
Feb 21, 2009
Messages
338
Re: 150 force

i've never done it... does 44 mph seem to slow for a 150 on a 16 ft bassboat?

Yes, depending on what prop you're running. I have a 150 Force on an 18' 1972 Reinell Trihull, modified transom, etc, etc. With just me in the boat, turns 62mph per the GPS. With 4 adults, fishing gear, etc, etc....46mph.
 

catfishwv

Seaman Apprentice
Thread starter
Joined
Mar 11, 2011
Messages
38
Re: 150 force

I put a hydrofoil on it. thats the only major thing I've done. Now i took the boat to a repair shop and had a new impeller put in it. when I got the boat back the throttle bar was off the engine so I clipped it back on. it seems to open all the way up on full throttle. could a dirty fuel filter cause this? also I should say I have to hit the reset switch on the tilt and trim to make it re-engage sometimes.
 

Robert D

Petty Officer 1st Class
Joined
Feb 21, 2009
Messages
338
Re: 150 force

I put a hydrofoil on it. thats the only major thing I've done. Now i took the boat to a repair shop and had a new impeller put in it. when I got the boat back the throttle bar was off the engine so I clipped it back on. it seems to open all the way up on full throttle. could a dirty fuel filter cause this? also I should say I have to hit the reset switch on the tilt and trim to make it re-engage sometimes.

Hydrofoil on mine takes 6 mph off the top end. However I put it back on, helps out in rough water. Dirty fuel filter can cause problems, as well as ignition timing, a weak coil, bad/old fuel, carbs out of adjustment, bad rectifier......just a few things that come to mind.
 

catfishwv

Seaman Apprentice
Thread starter
Joined
Mar 11, 2011
Messages
38
Re: 150 force

replaced the fuel filter and readjusted the throttle linkage it seemed fine now. I fired it up using muffs and it purred like a kitten didn't seem to miss a beat. called the repair shop and he told me the guy had unhooked the throttle linkage to get to the impeller. strange i know . but it was short by about a inch. so I adjusted it to where it should be wide open on full throttle. and locked it back down. now it starts smooth and idles great. thanks for the help
 
Top