UpforAllnight
Cadet
- Joined
- Apr 14, 2009
- Messages
- 9
I have a '58 johnso 5.5 hp that will not start. I purchased this motor about 2 weeks ago. This motor has had two owners the first owned the motor from '58 until 2006. the first owner stoped using the motor because he could not pull the rope any longer, and the second owner aquired the motor because it was attached to the boat he wanted.
My point is the motor sat for quite some time.
I got the motor home hooked up the fuel can, and gave the rope 4 pulls, and it started right up, however when I shut the choke off the engine would die.
So, I started searching on iboats. Awakening a sleeping out board, carb needle vave adjustment, ect.
I realized it was time for some updates on this motor.
1)replaced water pump
2)replaced points and condenser
3) coils they were all cracked
4)new plugs and wires
5)carb kit, soaked in carb cleaner 2 days
6) tested spark with a tester 3/8 gap
I now have the same problem anoter poster has that my engine will only run if I squirt fuel into the carb.
I am waiting on a manual now hoping for some more details.
A question I have regaurding my carb is when you flip the carb uside down to see if it is parallel with the bowl how do you adjust it? should you spacers, or just back off the seat?
Any addition advise would be great!
Thanks,
Jon
My point is the motor sat for quite some time.
I got the motor home hooked up the fuel can, and gave the rope 4 pulls, and it started right up, however when I shut the choke off the engine would die.
So, I started searching on iboats. Awakening a sleeping out board, carb needle vave adjustment, ect.
I realized it was time for some updates on this motor.
1)replaced water pump
2)replaced points and condenser
3) coils they were all cracked
4)new plugs and wires
5)carb kit, soaked in carb cleaner 2 days
6) tested spark with a tester 3/8 gap
I now have the same problem anoter poster has that my engine will only run if I squirt fuel into the carb.
I am waiting on a manual now hoping for some more details.
A question I have regaurding my carb is when you flip the carb uside down to see if it is parallel with the bowl how do you adjust it? should you spacers, or just back off the seat?
Any addition advise would be great!
Thanks,
Jon