which wires do i "tap" into to connect a kill switch?
B boydog Petty Officer 2nd Class Joined Oct 10, 2005 Messages 131 Feb 17, 2019 #1 which wires do i "tap" into to connect a kill switch?
wrench 3 Commander Joined Aug 12, 2012 Messages 2,108 Feb 17, 2019 #2 You need to connect the switch between the blue wire and the blue/white wire.
B boydog Petty Officer 2nd Class Joined Oct 10, 2005 Messages 131 Feb 17, 2019 #3 i did and it didnt kill it when i pulled the cord, maybe its not a good switch, ill buy a new one and advise
i did and it didnt kill it when i pulled the cord, maybe its not a good switch, ill buy a new one and advise
Vic.S Rear Admiral Joined May 4, 2004 Messages 4,720 Feb 18, 2019 #4 boydog said: i did and it didnt kill it when i pulled the cord, maybe its not a good switch, ill buy a new one and advise Click to expand... Check the one you have . If is defective replace it but if it is good you'll need to look for anther problem. The motor should stop if you short the wires mentioned together. If it does not you will have to find out why not. Does it stop OK with the key switch
boydog said: i did and it didnt kill it when i pulled the cord, maybe its not a good switch, ill buy a new one and advise Click to expand... Check the one you have . If is defective replace it but if it is good you'll need to look for anther problem. The motor should stop if you short the wires mentioned together. If it does not you will have to find out why not. Does it stop OK with the key switch
wrench 3 Commander Joined Aug 12, 2012 Messages 2,108 Feb 18, 2019 #5 Are you tapping in at the key switch?
B boydog Petty Officer 2nd Class Joined Oct 10, 2005 Messages 131 Feb 18, 2019 #6 it does shut off with the key switch i will check the switch and revert back thanks
B boydog Petty Officer 2nd Class Joined Oct 10, 2005 Messages 131 Feb 18, 2019 #7 no im not going to the key switch, is that the problem?
wrench 3 Commander Joined Aug 12, 2012 Messages 2,108 Feb 18, 2019 #8 boydog said: no im not going to the key switch, is that the problem? Click to expand... No, but if you use the wires on the two "m" terminals on the key switch you know that you have the correct ones.
boydog said: no im not going to the key switch, is that the problem? Click to expand... No, but if you use the wires on the two "m" terminals on the key switch you know that you have the correct ones.
